[PDF] Top 20 Non-destructive analysis: PIXE with high-energy ion beam at the ARRONAX cyclotron
Has 10000 "Non-destructive analysis: PIXE with high-energy ion beam at the ARRONAX cyclotron" found on our website. Below are the top 20 most common "Non-destructive analysis: PIXE with high-energy ion beam at the ARRONAX cyclotron".
Non-destructive analysis: PIXE with high-energy ion beam at the ARRONAX cyclotron
... L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d’enseignement et de recherche français ... Voir le document complet
2
High energy PIXE: A tool to characterize multi-layer thick samples
... set-up High energy experiments were carried out at ARRONAX cyclotron [14] using 68 MeV ...protons. The beam diameter on the sample was in the range of 1 ... Voir le document complet
15
Ion beam analysis of three dimensional (3D) structures for applications in nanotechnology
... about the results of my work throughout these three years of PhD studies at the "Commissariat à l'Energie Atomique et aux Energies Alternatives (CEA)", in the "Laboratoire de ... Voir le document complet
189
THE C70 ARRONAX AND BEAM LINES STATUS
... INTRODUCTION ARRONAX, an acronym for "Accelerator for Research in Radiochemistry and Oncology at Nantes Atlantique", is a high energy (70 MeV for protons) and high intensity ... Voir le document complet
4
Effect of annealing environment on the memory properties of thin oxides with embedded si nanocrystals obtained by low-energy ion-beam synthesis
... 共MOSFET兲 with nanoc- rystals embedded within the gate SiO 2 have recently at- tracted much attention for high-density, low-voltage memory ...Among the different techniques aiming ... Voir le document complet
5
Combined PIXE/PIGE with the high-energy beams of the ARRONAX cyclotron
... Bulk analysis (density and stoichiometry) Determination of the thickness, the density and the mass fraction of a Ni/Ga alloy deposited on a gold substrate (to be used as target at ... Voir le document complet
2
R&D activities on RF contacts for the ITER ion cyclotron resonance heating launcher
... within the ITER ICRH launcher to allow assembling, sliding and to lower the thermo-mechanical ...kA at 55 MHz in steady-state conditions, in the vacuum environment of ...during the ... Voir le document complet
6
Low energy Ne ion beam induced-modifications of magnetic properties in MnAs thin films
... on the effect of ion bom- bardment on manganese arsenide thin ...that the thermal hysteresis is suppressed when an intense magnetic fields is applied due to local irradiation-induced ...not ... Voir le document complet
9
Non resonant transmission modelling with Statistical modal Energy distribution Analysis
... modal Energy distribution Analysis (SmEdA) can be used as an alternative to Statistical Energy Analysis for describing subsystems with low modal ...predicts the power flow ... Voir le document complet
34
In-Target Yields forRadioactive Ion Beam (RIB) Production with EURISOL
... estimate the in-target RIB yields in direct targets we had to study 320 different configurations of cylindrical targets, whose characteristics are summarized in TABLE ...I. The choice of the ... Voir le document complet
10
Study of the variability of active galactic nuclei at very high energy with H.E.S.S.
... Along with the improvement of our knowledge of the Universe, increasingly detailed, var- ied and precise data sets appeared necessary to solve the remaining ...variable the available ... Voir le document complet
137
Approach to equilibrium in high energy heavy ion collisions
... L’IPhT ne serait pas ce qu’il est sans le support sans failles du personnel administratif, sans aucun doute le plus efficace de France (sans contestation possible sur l’échantillon qu’il ma été donné de voir durant ma ... Voir le document complet
200
Experimental and Modeling Analysis of Graphite Electrodes with Various Thicknesses and Porosities for High-Energy-Density Li-Ion Batteries
... comparison with interpolated experimental data for L1D1 and L4D2 at I = 10 mA cm −2 is displayed in Figure 11 ...data at I = 10 mA cm −2 . Consistent with previous observations, solid- ... Voir le document complet
14
Damping of the fast Alfven wave in ion-cyclotron resonance heating
... Such regions are commonly designated as "mode-conversion regions." In the conventional treatment of ICRF heating, starting with a k 11 (component of the wave ve[r] ... Voir le document complet
32
Superconducting booster cyclotron studies at GANIL
... for the deposit and dissemination of sci- entific research documents, whether they are pub- lished or ...not. The documents may come from teaching and research institutions in France or abroad, or from ... Voir le document complet
4
Beam Energy and Centrality Dependence of Direct-Photon Emission from Ultrarelativistic Heavy-Ion Collisions
... describe the integrated-direct-photon ...about the strongly coupled quark-gluon plasma (QGP) produced in heavy ion collisions and its “fireball” evolu- tion to hadron resonance ...interact ... Voir le document complet
10
PIXE Analysis for the pigment identification in the Nizet manucript (18th century)
... CONDITIONS The PIXE measurements were performed with the cyclotron of the Institute of Nuclear and Atomic Physics and of Spectrometry of the University of Liege ... Voir le document complet
1
Characterization of nanostructured hexagonal boron nitride patterned via high-resolution ion beam lithography
... To better understand how the nanoscale patterning affected the absorption of light and the coupling to the phonons in h-BN, photo-thermal spectroscopy and imaging w[r] ... Voir le document complet
57
Beam-Energy Dependence of Charge Separation Along the Magnetic Field in Au + Au Collisions at RHIC
... of beam energy for three centrality bins in Au þ Au ...for the beam energies under study has been measured in our previous publications [21] .... The default values (dotted curves) are ... Voir le document complet
8
Non-destructive testing of concrete
... measure the interior strength of mass concrete, they do give information on the maturity and development of strength of a representative part of ...have the advantage of measuring quantitatively ... Voir le document complet
5
Sujets connexes