Science Arts & Métiers (SAM)

For the action "Optimize the whole product to minimize releases during distribution phase", two structuring of the problem have been proposed Table 2: In the first case, the

Sections 3.1.1, 3.1.2 and 3.1.3 deal withthe injection of the investigated standard yield stress fluid through the different porous media, in order to assess the ef-

As reported in the literature [16], the morphology of the coating is directly influenced by the surface conditions of the substrate, notably roughness or irregularities, suggesting that

Conclusions The experimental and numerical studies developed in this work, to analyze angular scratches 10, 20 and 30° on low carbon steel, provide the following conclusions: •The

According to the applied tensile tests on the printed specimens at the stated different print speed values, the tensile strength values of 65 ± 0.5, 55 ± 0.6, and 63 ± 1.3 were obtained

5b.Correlation between the laser intensity and the delamination width inside the composite target for two different inter-ply Results obtained by optical inspection of the same four

Schematization of the finishing gesture activity targeted by the cobotization project This diagram shows the following dimensions: − Finishing work mobilizes knowledge about products,

For the modeling of single reed wind instruments four objects are distinguished: the mouthpiece with reed, the tube, the tone hole with possible closing by a finger or a key, and