Science Arts & Métiers (SAM)

For the action "Optimize the whole product to minimize releases during distribution phase", two structuring of the problem have been proposed Table 2: In the first case, the

However, the aim is to control the sled’s acceleration, therefore the servo-control of acceleration was tested using both a Heaviside step function and a sinusoidal function Equation

Since at high stress amplitudes, the thermal and mechanical properties of the material can be changed because of the high temperature increase, this formulation was used to measure the

The basic principle is to measure the phase lag and the amplitude of the periodic temperature response produced on the sample surface by a modulated laser beam.19A thermal diffusion

Sections 3.1.1, 3.1.2 and 3.1.3 deal withthe injection of the investigated standard yield stress fluid through the different porous media, in order to assess the ef-

The trajectories in the stress/strain plane in figure 8 left, and even more convincingly in the instant modu- lus/strain plane in figure 8 right, illustrate the features to be

Conclusions The experimental and numerical studies developed in this work, to analyze angular scratches 10, 20 and 30° on low carbon steel, provide the following conclusions: •The

For the modeling of single reed wind instruments four objects are distinguished: the mouthpiece with reed, the tube, the tone hole with possible closing by a finger or a key, and