Science Arts & Métiers (SAM)

Pincers' opening Amplitudes in µm out.cyl.: outer cylinder in.cyl.: inner cylinder Residual 6,1 1,1 1,1 8,7 0 2 4 6 8 10 Initial residual Final residual Values in mm Simulated

Also true for the steel SNC that the hardness improves after plasma nitriding at a higher temperature of 500°C for 10 h and the present study has shown the significant improvement of

Ahmadi Institute of Mechanical Engineering I2M, TREFLE department, Arts et Métiers ParisTech - Talence, 33400 Key words: porous media, numerical simulation, inertial effects,

The goal of the present study is twofold: i to assess the capa- bility of a high-order shock-capturing central scheme, used in our previous works [32,35], to robustly predict

11.Wöhler curves of PPS/GF composite performed on PPS-90° and PPS-0° specimens under tensile-tensile fatigue loading at the frequency of 10 Hz and room temperature, R = 0.1.. 12.The

In short, the capability of laser cladding the CM247LC alloy was shown to depend on its local microstructure: for local pre-heating temperature below 1100 °C, dissolution of large

The trajectories in the stress/strain plane in figure 8 left, and even more convincingly in the instant modu- lus/strain plane in figure 8 right, illustrate the features to be

Thus, the analysis of those erratic trajectories that the fiber follow, should provide a very valuable information on the orientation state difficult to measure in 3D flows of