Science Arts & Métiers (SAM)

For the modeling of single reed wind instruments four objects are distinguished: the mouthpiece with reed, the tube, the tone hole with possible closing by a finger or a key, and

Validation using experimental data from the literature Lagoudas et al., 2012 The proposed identification procedure has been utilized to obtain the model parameters corresponding to the

For the action "Optimize the whole product to minimize releases during distribution phase", two structuring of the problem have been proposed Table 2: In the first case, the

Ahmadi Institute of Mechanical Engineering I2M, TREFLE department, Arts et Métiers ParisTech - Talence, 33400 Key words: porous media, numerical simulation, inertial effects,

The main aim of this research is to find the consequences of the drill wear on the surface quality of the hole such us the uncut fibers and dimensional variation of the diameter in the

As reported in the literature [16], the morphology of the coating is directly influenced by the surface conditions of the substrate, notably roughness or irregularities, suggesting that

Figure 10: Mean flow rate measured in each injector once installed on the compressor test rig for two different levels of supply pressure with continuous actuation, error bars are

The unknown thermal properties and related experimental parameters are identified by minimizing the gap between the measured signal and the theoretical response that accounts with the