Science Arts & Métiers (SAM)

For the modeling of single reed wind instruments four objects are distinguished: the mouthpiece with reed, the tube, the tone hole with possible closing by a finger or a key, and

For the action "Optimize the whole product to minimize releases during distribution phase", two structuring of the problem have been proposed Table 2: In the first case, the

The main aim of this research is to find the consequences of the drill wear on the surface quality of the hole such us the uncut fibers and dimensional variation of the diameter in the

Since at high stress amplitudes, the thermal and mechanical properties of the material can be changed because of the high temperature increase, this formulation was used to measure the

Sections 3.1.1, 3.1.2 and 3.1.3 deal withthe injection of the investigated standard yield stress fluid through the different porous media, in order to assess the ef-

As reported in the literature [16], the morphology of the coating is directly influenced by the surface conditions of the substrate, notably roughness or irregularities, suggesting that

The trajectories in the stress/strain plane in figure 8 left, and even more convincingly in the instant modu- lus/strain plane in figure 8 right, illustrate the features to be

According to the applied tensile tests on the printed specimens at the stated different print speed values, the tensile strength values of 65 ± 0.5, 55 ± 0.6, and 63 ± 1.3 were obtained