Science Arts & Métiers (SAM)

The localization method is based on the following physical phenomenon: a finger contact modifies the energy distribution of acoustic wave in a solid; these variations depend on the wave

The basic principle is to measure the phase lag and the amplitude of the periodic temperature response produced on the sample surface by a modulated laser beam.19A thermal diffusion

Sections 3.1.1, 3.1.2 and 3.1.3 deal withthe injection of the investigated standard yield stress fluid through the different porous media, in order to assess the ef-

The trajectories in the stress/strain plane in figure 8 left, and even more convincingly in the instant modu- lus/strain plane in figure 8 right, illustrate the features to be

The aim of this research is to evaluate: i some problems en- countered during the printing process of the PA6, and when they are overcome and successful print is attained, ii the effect

According to the applied tensile tests on the printed specimens at the stated different print speed values, the tensile strength values of 65 ± 0.5, 55 ± 0.6, and 63 ± 1.3 were obtained

5b.Correlation between the laser intensity and the delamination width inside the composite target for two different inter-ply Results obtained by optical inspection of the same four

Schematization of the finishing gesture activity targeted by the cobotization project This diagram shows the following dimensions: − Finishing work mobilizes knowledge about products,