• Aucun résultat trouvé

2021 Fall - CFD LAB 4

N/A
N/A
Info
Télécharger
Protected

Academic year: 2022

Partager "2021 Fall - CFD LAB 4"

Copied!
2
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

2021 Fall - CFD LAB 4

Number of Students

Total 9

Submitted 9

Not Submitted 0

Average 90.56

Standard deviation 8.93

(2)

Comments

 Two students could not prepare the required figures properly and the discussion about the simulation results is not enough

 Several students could not have the frequency of drag force correctly, so they calculate wrong Strouhal number

 Some of students put the wrong answer for the drag force of each component of Ahmed body

 Also, a few of students extracted inappropriate force value from the experiment figure to compare with simulation results

Références

Télécharger maintenant ( PDF - 2 Page - 42.73 KB )

Documents relatifs

2020 Fall - CFD LAB 4

• Some of students could not derive the frequency of drag coefficient correctly, so calculate

2019 Fall - CFD LAB 1

 Several students used wrong empirical equation to get the fully developed length, so they can’t compare the CFD result correctly for both laminar and turbulent conditions.. 

2019 Fall - CFD LAB 2

 Several students answered that 1 st order upwind scheme gives out results closer to the asymptotic range.  Some of student indicated validated

2019 Fall - CFD LAB 3

 Several students couldn’t indicate separation point or reattaching point correctly.  Some of student did not answered for all questions in

2019 Fall - CFD LAB 4

 Several of students indicated wrong sign for drag coefficient of Ahmed Body(Front Part

CFD LAB #2 REPORT

In case you need to answer for pressure coefficients, averaging ‘P’ and ‘Ug’ might be a good idea.. Exercise 9.4 - None

REPORT OF CFD LAB 1

For problem 9.3, many students answered that the grid sets containing grid #8 is more sensitive respect to the refinement ratio.. Grid sets containing grid #4 is more

REPORT OF CFD LAB 2

Learned how to model the airfoil and analyze the lift and drag while changing the angle of attack.. Required materials are notified at the end of the manual