• Aucun résultat trouvé

Preliminary experimental analysis of the surface topography formation during laser polishing H13 tooling steel using statistical characteristics of the surface amplitude distribution

N/A
N/A
Protected

Academic year: 2021

Partager "Preliminary experimental analysis of the surface topography formation during laser polishing H13 tooling steel using statistical characteristics of the surface amplitude distribution"

Copied!
7
0
0

Texte intégral

Loading

Figure

Fig. 1. Statistical digital twin of the LP process.
Fig. 1. Statistical digital twin of the LP process.
Fig. 3. LP samples with a) ground initial surface and b) flat initial surface.
Fig. 6. Effect of the laser power on averaged transversal X-X cross-sections.
+2

Références

Documents relatifs

The development of a novel biodiesel production alternative was accompanied by Life Cycle Management and Risk Analysis in an iterative procedure nearly from the beginning

As our goal is to study the general computational power of a given TQFT, we find it fruitful to abstract the data presented here in the form of an algebraic model of anyons

The data used in this study was primarily from the Taiwan Province Government and the Urban and Housing Development Committee. CONTENTS ABSTRACT 1 ACKNOWLEDGEMENTS

Pour l’heure, la Lune est déserte et il ne s’y trouve qu’une poignée d’émetteurs radio et strictement aucune pollution lumineuse ni luminance nocturne du ciel, des

Le récit donne davantage d’éléments sur le travail et les relations qu’entretient Nico avec les adultes, puisque dans le chapitre « lunedì », il est le premier

Under steady state conditions the total outside supply rate equals the .air leakage rate through exterior walls plus air leakage rate through bottom separation

EMBRACE, Epidemiological Study of BRCA1 and BRCA2 Mutation Carriers; FCCC, Fox Chase Cancer Center; HEBON, Hereditary Breast and Ovarian Cancer Research Group Netherlands; ILUH,

Title Page Abstract Introduction Conclusions References Tables Figures ◭ ◮ ◭ ◮ Back Close Full Screen / Esc.. Printer-friendly Version