• Aucun résultat trouvé

Real Time Implementation of Grid-connectioncontrolusing Robust PLL for WECS in VariableSpeedDFIG-based on HCC

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Real Time Implementation of Grid-connectioncontrolusing Robust PLL for WECS in VariableSpeedDFIG-based on HCC"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

The 5th International Conference on Electrical Engineering (ICEE 2017) 2017

Real Time Implementation of Grid-connection controlusing Robust PLL for WECS in Variable

SpeedDFIG-based on HCC

Fayssal AMRANE, Azeddine CHAIBA, Bruno FRANCOIS, Badreddine BABES

Abstract : This paper presents the experimental real timeimplementation of a grid-connection field-oriented control (FOC)for wind turbine based on a doubly fed induction generator(DFIG). A control law is synthesized using a hybrid FOCHysteresisCurrent Controller (HCC) in Rotor side converter(RSC) and the stator is connected to grid via robust PLL (phaselocked loop). The regulation is achieved below the synchronousspeed (Hypo-synchronous mode). The implementation is realizedusing dSPACE1104 single board card control and acquisitioninterface. The obtained results of the proposed control presenthigh performance in steady and transient states with low THD ofthe stator injected current to the grid (<5%).

Keywords : Doubly fed induction generetor (DFIG), Field oriented control (FOC), Hysteresis current controller (HCC), Rotor side converter (RSC), dSPACE1104

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Télécharger maintenant ( PDF - 1 Page - 7.82 KB )

Documents relatifs

Predictive Power Control of Doubly-Fed Induction Generator for Wave Energy Converters

Index Terms —Wave energy converter (WEC), doubly-fed induction generator (DFIG), predictive power control..

Modeling and Control of a Marine Current Turbine Driven Doubly-Fed Induction Generator

Seifeddine BENELGHALI, Mohamed BENBOUZID, Jean-Frederic CHARPENTIER - Modeling and Control of a Marine Current Turbine Driven Doubly-Fed Induction Generator - IET Renewable

Experimental Design of Stand-alone FieldOriented Control for WECS in Variable SpeedDFIG-based on Hysteresis Current Controller

Keywords : Doubly fed induction generetor (DFIG), Field oriented control (FOC), Hysteresis current controller (HCC), Rotor/Stator side converter (RSC/SSC), dSPACE1104. Centre

Experimental Design of Stand-alone Field Oriented Control for WECS in Variable Speed DFIG-based on

Daryabeigi, &#34;A Combined Vector and Direct Power Control for DFIG-based Wind Turbines&#34;, IEEE Transactions on Sustainable Energy, Vol. [3] Heng Nian, Yipeng Song,

Real Time Implementation of Grid-connection control using Robust PLL for WECS in Variable Speed DFIG-based on HCC

[18] Fayssal Amrane, Azeddine Chaiba and Ali Chebabhi: &#34;Improvement Performances of Doubly Fed Induction Generator via MPPT Strategy using Model Reference Adaptive Control

Chapter 3 Control of the Doubly-Fed Induction Generator based Wind Turbine Generator System

The bandwidth and controller gains for the current, power, torque and DC-link voltage control loops, tuned for the rated conditions, are presented in Table-3.2.. Table 3.2

Robust Control of Doubly Fed InductionGenerator for WindTurbine UnderSub-Synchronous Operation Mode

For to improve the controllerrobustness, the study is validated through simulation using software Matlab/Simulink, studies on a 1.5 MW DFIG windgeneration system compared

Robust Control of Doubly Fed Induction Generator for Wind Turbine Under Sub-Synchronous Operation Mode

Nowadays, wind generation system based on a doubly fed induction generator (DFIG) are employed widely in large wind farms fat has its many advantages: a very good energy