• Aucun résultat trouvé

Robust Control of Doubly Fed InductionGenerator for WindTurbine UnderSub-Synchronous Operation Mode

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Robust Control of Doubly Fed InductionGenerator for WindTurbine UnderSub-Synchronous Operation Mode"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

Enegy Procedia

Volume 74, Issue 2015, 2015, Pages 886-899

Robust Control of Doubly Fed Induction Generator for WindTurbine Under

Sub-Synchronous Operation Mode

Khouloud BEDOUD, Mahieddine Ali-rachedi, Tahar Bahi, Rabah Lakel, Azzeddine Grid.

Abstract: This paper presents a modeling and a robust control of doubly fed induction generator for wind generation system. The wholesystem is presented in d-q-synchronous reference frame. The regulation of the electromagnetic torque , stator reactive powercontrol and neuronal controller are applied in order to control the rotor currents of the DFIG. For to improve the controllerrobustness, the study is validated through simulation using software Matlab/Simulink, studies on a 1.5 MW DFIG windgeneration system compared with conventional proportional integral controller. Performance and robustness results obtained willbe presented and analyzed.

Keywords : wind power generation, modeling, Control, doubly fed induction generator, Neuronal controller, performances.

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Télécharger maintenant ( PDF - 1 Page - 7.59 KB )

Documents relatifs

High-Order Sliding Mode Control for DFIG-Based Wind Turbine Fault Ride-Through

Simulations using the NREL FAST code on a 1.5-MW wind turbine are carried-out to evaluate ride-through performance of the proposed HOSM control strategy in case of grid frequency

Hybrid sliding mode control of DFIG with MPPT using three multicellular converters

Abstract: This paper deals with hybrid sliding mode control of Doubly Fed Induction Generator DFIG with Maximum Power Point Tracking MPPT connected by rotor side to three

Sensorless Control of Doubly-Fed Induction Generator-Based Wind urbines using a High-Order Sliding Mode Observer

Sensorless Control of Doubly-Fed Induction Generator-Based Wind urbines using a High-Order Sliding Mode Observer... Sensorless Control of Doubly-Fed Induction Generator-Based Wind

Robust Control of Doubly Fed Induction Generator for Wind Turbine Under Sub-Synchronous Operation Mode

Nowadays, wind generation system based on a doubly fed induction generator (DFIG) are employed widely in large wind farms fat has its many advantages: a very good energy

Modeling and Control of the Wind EnergyConversion Systems Based on DFIG Under Sub-and Super-Synchronous Operation Modes

Abstract: In this work, the modeling and control of the Wind Energy Conversion Systems (WECS) based on doubly fed induction generator (DFIG) are presented.. Firstly, we developed

Chapter 5 Test Bench for the Doubly-Fed Induction Generator based Wind Turbine Generator System

1) Interchanging the chariots to observe if the problem is due to a component installed in the chariot. 2) Measuring all three rotor currents instead of two. 3)

Chapter 3 Control of the Doubly-Fed Induction Generator based Wind Turbine Generator System

The bandwidth and controller gains for the current, power, torque and DC-link voltage control loops, tuned for the rated conditions, are presented in Table-3.2.. Table 3.2

Using simulation models to simulation models to improve the

& By By using the using the Biomas Biomas multi multi - - agent system to agent system to s s imulate imulate transfers at territorial scale transfers at territorial