Charge Pumps for Implantable Microstimulators in Low and High-Voltage Technologies

Calculated phase lost for applied LV MOSFETs Vds voltage measurement The following figure reports a simulation result of this effect at nominal power, Vin=330V, f=150kHz... SR

A screw clamp was set around flexible tubing at the pump outlet side to produce the required pressure conditions for left ventricle assist devices (100 mm Hg). The results of

If it is possible to apply a high electric field, which is enough to cause field ionization of image gases, even to the tip with a larger radius of curva- ture, a further extension

Single-ended charge pump circuits are an elegant approach to system flexi- bility, low-power consumption, minimization of pads and external compo- nents, or area. T he output

breakdown voltage (see e.g. It allows widening the parameter ranges and being closer to the 100% efficiency, but one should keep in mind that the area used by the protection itself

and 6 , I show my work as part of the second Einstein Telescope mock data and science challenge that covers the analysis, parameter estimation and application to

Loss-of-function mutants for lamina, LINC complex components or chromatin remodellers and modifiers were then evaluated for their impact on nuclear morphology as well as

This work enable to conclude on the feasibility of stacking high voltage analog devices in a 3DSI for More-than-Moore applications. Low-cost and low thermal budget 2.5V