..
Machining Science and Technology
CONTENTS Volume 14, Number 1 2010
COMBINED EFFECTS OF FLANK AND CRATER WEAR ON CUTTING FORCE MODELING lN ORTHOGONAL MACHINING-PART 1:MODEL DEVELOPMENT 0 Yu Long
and Yang Huang 1
COMBINED EFFECTS OF FLANK AND CRATER WEAR ON CUTTING FORCE MODELING lN ORTHOGONAL MACHINING- PART Il: BAYESIAN APPROACH-BASED MODEL VALIDATION
0 Yu Long, Yang Huang, and Xiaoqian Sun 24 SIMULATED ANNEALING TO ESTIMATE THE OPTIMAL
CUTTING CONDITIONS FOR MINIMIZING SURFACE
ROUGHNESS lN END MILLING Ti-6AI-4V 0 Azlan Mohd Zain,
Habibollah Haron, and Safian Sharif 43
CONDITION MONITORING FOR INDEXABLE CARBIDE END MILL USING ACCELERATION DATA 0 Justin L. Milner
and John T. Roth 63
SIMULATION OF END MILLING OPERATION FOR PREDICTING CUTTING FORCES TO MINIMIZE TOOL DEFLECTION
BY GENETIC ALGORITHM 0 R. Jalili Saffar and M. R. Razfar A MODEL-BASED ANALYSIS OF ORTHOGONAL CUTTING FOR SINGLE-CRYSTAL FCC METALS INCLUDING
CRYSTALLOGRAPHICANISOTROPY 0 Nithyanand Kota and O. Burak Ozdoganlar
81
102 MODELING OF WHITE AND DARK LAYER FORMATION
lN HARD MACHINING OF AISI 52100 BEARING STEEL
0 D. Umbrello, A. D. Jayal, S. Caruso, O. W. Dillon, and 1. S. Jawahir
128
10910344(2010)14(1)
