Machining Science and Technology
CONTENTS Volume 13, Number 4 2009
SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION lN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS
0 y B. Guo, W. Li, and 1. S. Jawahir 437
THE EFFECTOF A YIELD DROP ON CHIP FORMATION OF SOFT
CARBON STEELS 0 T. H. C. Childs and R. Rahmad 471 EXPERIMENTAL STUDIES AND MODELING OF HEAT
GENERATION lN METAL MACHINING 0 A. Liljerehn, V. Kalhori,
and M. Lundblad 488
CUTTING DISTURBANCES INFLUENCED BY VARIATIONS lN CONTACT SURFACE GEOMETRY 0 Antun Stoic,
Franci Pusavec, and Janez Kopac 516
MACHINABILITY IMPROVEMENT THROUGH HEAT TREATMENT lN 8620 LOW-CARBON ALLOYED STEEL 0 Luis Felipe Verdeja,
José Ignacio Verdeja, and Roberto Gonzâlez 529
RESIDUAL STRESSES ON INCONEL 718 TURBINE SHAFT SAMPLES AFTER TURNING 0 T. Berruti, M. Lavella,
and M. M. Gola 543
VORTEX MACHINING: LOCALIZEDSURFACE MODIFICATION USING AN OSCILLATING FIBER PROBE 0 B. K. Nowakowski,
S. T. Smith, B. A. Mullany, and S. C. Woody 561
AN INVESTIGATION INTO DIMENSIONAL ACCURACY AND SURFACE FINISH ACHIEVABLElN DRY TURNING
0 N. H. Rafai and M. N. Islam 571
Following Page 589:
Title Page to Volume 13
Table of Contents to Volume 13
Author Index to Volume 13
10910344(2009)13(4)
~ Taylor& Francis
~
Taylor & Francis Group1 1 l' 1
.)
