• Aucun résultat trouvé

Identification of a 3D Shape from a 2D Design: Application to a Swimming Monofin

N/A
N/A
Protected

Academic year: 2022

Partager "Identification of a 3D Shape from a 2D Design: Application to a Swimming Monofin"

Copied!
18
0
0

Texte intégral

Références

Documents relatifs

If the background  ow is inertially unstable, turning levels can disappear and the wave can now reach the critical level.. Then over-re ection, over-transmission and absorption

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

it) To design the stator, we choose the following quantities. a dimensionsless factor F representing the relative saturation of ~tator and rotor teeth.. the height h~, of stator

Our research showed that an estimated quarter of a million people in Glasgow (84 000 homes) and a very conservative estimate of 10 million people nation- wide, shared our

In order to be able to describe large concentration cases, it is useful to introduce a packing concentration, Φ pack , which is defined as the particle volume fraction of a

The measurement was focused on scenarios with LOS (as opposed to LOS blockage), which is the most favorable case for mmWave MIMO communications 2. A major difference of this paper,

The general darts throwing movement is performed using mostly the elbow joint and during the throwing separations between the minimum inertia axis (e 3 ), shoulder- center

joli (jolie), pretty mauvais (mauvaise), bad nouveau (nouvelle), new petit (petite), little vieux (vieille), old.. ordinal