IRM
lnt. J.Machining andMachinability of Materialt, Vol. 6, NOS.«~ ~
Contents Le 0 1 SI:P.2309
ispublished
SPECIAL ISSUE: 10TH CIRP WORKSHOPlIN MODELLING OF MACHINING OPERA TIONS
y)€ 735
Guest Editors: Fabrizio Micari, Luigino Filice and Domenico Umbrello
only) € 1,025
..
...
...
,...
..
"'" . ..
...
...
...
tg equivalent to
-...
""'D""""
69
83
95
106
120
Editorial
Fabrizio Micari, Luigino Filieeand DomenicoUmbrello
Effect of imishing methods on surface characteristics and performance of precision components in rolling/sliding contact
F.Hashimoto, S.N.
Melkote,R. SinghandR. KalilWhat is expected froID numerical simulation on machining process Takahiro Shirakashi
Runtime and accuracy issues in three-dimensional flnite element simulation of machining
Chris Fischer
Prediction of temperature distribution in the cutting zone using flnite difference approach
Wit Grzesik and Marian Bartoszuk
Numerical analysis of crack propagation during the burr formation process of metals
J. Regel,A. Stoll and J. Leopold
Investigations on the adjustment of the modelling section in 2D simulations of milling process'es
E. Uhlmann,A. Mattes, M. Graf von der Schulenburg and Robert Gerstenberger
Geometrie simulation of bail end milling and application for the precise machining
Hisanobu Terai, Teruyuki Asao and Yoshio Mizugaki Diffusion wear modelling in 3D cutting process
E. Ceretti,ClaudioGiardini,AldoAttanasio,L. Filiee,StefaniaRizzuti and D. Umbrello
Experimental evaluation of lubricant influence on residual stress in turning operations
A. Attanasio, E. Ceretti, M. Gelfi and C. Giardini
Effect of the microstructure on the tool/chip tribological contact in bard turning of 100Cr6 bearing steel
MalekHabak,JeanLou Lebrunand Daniel Badie-Levet
1 1
1 3
Il,
16
35
lingat the
1
1 43
,
ing and 1 54
