• Aucun résultat trouvé

Inferential sensor – Based adaptive principal componentsanalysis for mechanical properties prediction and evaluation

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Inferential sensor – Based adaptive principal componentsanalysis for mechanical properties prediction and evaluation"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

measurement

Volume 46, 2013, Pages 3683-3690

Inferential sensor – Based adaptive principal componentsanalysis for mechanical properties

prediction and evaluation

Bouhouche Salah, Laib dit Leksir Yazid, Hazem Tarek, Bast Jurgen

Abstract: This paper is concerned with a method for on-line quality prediction and evaluation ofmechanical properties in metal testing. This method uses an Adaptive Principal ComponentAnalysis (APCA) as a multi predictor of different sub-models de?ning the mechanical prop-erties such as constraints limits and elongation. The PCA technique, characterized by itsmultivariate component, is strongly recommended to model a multi-input-multi-outputsystem. The complex system is generally known as a non-linear and unsteady state pro-cess. The PCA method is a linear projection. To adapt it and to improve the prediction accu-racy, a variant of this method is considered based on iteratively using a speci?c algorithm.This kind of approaches is applied for constructing an inferential model, which allows areliable and accurate predictor. Simulation results, based on the measured and computeddata using the above-cited method, show that the proposed approach is easily implement-able and give an accurate prediction.

Keywords : Soft sensor, Mechanical testing, Adaptive principal component analysis, Uncertainties evaluation

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Télécharger maintenant ( PDF - 1 Page - 7.79 KB )

Documents relatifs

this this is

If external lines are to be used then the corresponding port pins should be programmed as bit ports with the correct data direction. Finally, theCo~nter/Timer

A weighted-average alternating minimization method is proposed based on this new formulation and a convergence analysis of the method is carried out

Obviously, the WAAMM result is better than the FCSA reconstruction and the proposed method is very well suited to the case of strong noise and can improve image reconstruction

Inferential sensor –Based adaptive principal components analysis for mechanical properties prediction and evaluationSalah Bouhouche a, Laib dit Leksir Yazid

This method uses an Adaptive Principal Component Analysis (APCA) as a multi predictor of different sub-models defining the mechanical properties such as constraints limits

This internship is a part of the Blockchain for Fintech &amp

This problem can be solved by Blockchain based solutions where Individual can develop the sovereign controller of their own identity credentials.. Our objective is to develop

Is this Model for Real? Simulating Data to Reveal the Proximity of a Model to Reality

Heatmaps of (guess vs. slip) LL of 4 sample real GLOP datasets and the corresponding two simulated datasets that were generated with the best fitting

This is it! Selection and Preferences for Books

In the post task questionnaire, participants using the baseline interface were asked to indicate the usefulness of the book-bag in general while participants

A method for the segmentation of images based on thresholding and applied to vesicular textures

In image processing, a segmentation is a process of partitioning an image into multiple sets of pixels, defined as super-pixels, in order to have a representation which is

A Statistics Based Prediction Method for Rendering Application

The experimental results show that the proposed method improve the prediction accuracy about 60% and 75.74% for train- ing set and test set, which provides reasonable basis