• Aucun résultat trouvé

Structure and Magnetic Properties of Ternary

N/A
N/A
Protected

Academic year: 2021

Partager "Structure and Magnetic Properties of Ternary"

Copied!
1
0
0

Texte intégral

(1)

Home>Journal of Nano Research>Journal of Nano Research Vol. 47> Structure and Magnetic Properties of Ternary...

Paper Title:

Structure and Magnetic Properties of Ternary Nanosized FeAlSn and CuFeCo Powders Synthesized by Mechanical Milling

Abstract

Ternary Fe72Al26Sn2and Cu70Fe18Co12alloys were obtained by mechanical alloying of pure Fe, Al, Sn, Cu and Co powders using a high energy ball mill. X-ray diffraction and electron microscopy supported by magnetic measurements have been applied to follow changes in the microstructure, phase composition and magnetic properties in dependence on milling time.

With the increase of milling time all Al and Sn atoms dissolved in the bcc Fe and the final product of the MA process was the nanocrystalline Fe (Al, Sn) solid solution in a metastable state with a large amount of defects and mean crystallite size of 5 nm. However, the obtained crystallite size value is about 10 nm for the ball milled Cu70Fe18Co12powders. The electron microscope observations show the morphology of powder particles. Magnetic properties of the nanocrystalline mechanically alloyed FeAlSn and CuFeCo were also investigated and were related to the microstructural changes.

Keywords

CuFe Solid Solution,DRX,FeAl,Mechanical Alloying,SEM,VSM

Références

Documents relatifs

Moreover it transpires that the vacancy with smallest energy is that situated on an iron site and with 8 aluminium atoms neighbours, and that at low

We report in this paper quantitative measurements of the magnetization in the superconducting regime on a good quality (SN) sample and compare the re- sults to those obtained

Not to lar- ge changes of magnetic susceptibility with Fe con- tent suggest that only a small part of all Fe atoms retains their magnetic character in NbjGa.. This depends

MAGNETIC PROPERTIES OF AMOR- PHOUS AND CRYSTALLINE Fe-Hf-Si ALLOYS IN THE VICINITY OF Fe3Si... JOURNAL DE

Suite à la série de mesure effectuée sur l’installation RX de l’hôpital orthopédique du CHUV, nous avons pu analyser l’impact de la mise en place du tablier

ty, one is lead to believe into a second order tran- sition of the solid along the melting line, such that its temperature Tt increases with increasing field, as shown on figure

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

With the increase of milling time all Co atoms became dissolved in the bcc Fe and the final product of the MA process was the nanocrystalline Fe (Co) solid solution with a