• Aucun résultat trouvé

Study and numerical simulation of ultrasonicsignals for uniaxial stressed specimen

N/A
N/A
Protected

Academic year: 2021

Partager "Study and numerical simulation of ultrasonicsignals for uniaxial stressed specimen"

Copied!
1
0
0

Texte intégral

(1)

Conférence Internationale sur le Soudage, le CND et l’Industrie des Métaux, IC-WNDT-MI’10 2010

Study and numerical simulation of ultrasonic signals for uniaxial stressed specimen

M. Mekideche, A. Bouhadjera, T. Benkdidah, M. Grimess, S. Haddad

Abstract : In some fields of engineering construction, the aluminum alloys become attractive materials due to their mechanical properties. Taking this fact into account, a prism-shaped specimen of aluminum AA2017A is investigated under uniaxial stress and the measurements are performed considering two methods. For ultrasonic wave propagating normal to the loading direction, the ultrasonic mode conversion is considered. But for the waves propagating parallel to loading direction, the normal incidence direct contact transducer is adapted. Then, we present a numerical simulation ofultrasonic signal of received echo, and highlight the acoustoelasticity effect that involves a linear dependence between time delay separating the received ultrasonic signals and the undergoing forces

Keywords : soudage, cnd, l’Industrie des Métaux

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

While the direct ultrashort pulses are on the way, one could still exploit the advantages of parametric sources: wavelength tunability and higher pulse energies, while pumping with

The pattern matching system can match sub- trees based on forms, lemmas, part-of-speech tags, pres- ence of a morphological feature, value of the morphologi- cal feature, incoming

Qobs [numeric] time series of observed discharges [mm/time step] HydroModel [character] name of the function of the hydrological model used.. 12 ShinyGR Author(s) Olivier Delaigue

The key idea is that A-stable (or L-stable) method + high precision allow to choose large time steps: as a result, the method, even if each step is expensive, will be much less

Annual lamination counting can be used to establish a precise chronology that could then be applied for the reconstruction of water quality variations with time

9 Predicted and experimental BSA breakthrough curves under binding condition for the Sartobind Nano1mL device under (A) the different operating flow rates, when a BSA loading

First, we can estimate E by using the maximum likelihood estimate (MLE). This is a function of our training data. Suppose our training data consists of the instances xi

An important design challenge when developing a new autonomous system is deciding on the most efficient level of automation and autonomy. In general, as automation