Machining Science and Technology

Machining Science and Technology

CONTENTS Volume 16, Number 2

DYNAMIC ANALYSIS OF THE LENGTHENED SHRINK-FIT

HOLDERAND CUTTINGTOOL SYSTEM lN HIGH-SPEED MILLING D Houming Zhou, Chengyong Wang, Dewen Tang, and Ruitao Peng HO LE MAKING USING BALL HELICAL MILLING ON TITANIUM ALLOYS D David Olvera, Luis Norberto Lapez de Lacalle,

Gorka Urbikain, A. Lamikiz, P. RodaI, and 1. Zamakona

CHARACTERIZATION OF FRICTIONCOEFFICIENT AND HEAT PARTITION COEFFICIENT BETWEEN AN AUSTENITIC STEEL A/S/304L AND A TiN-COATED CARBIDE CUTTING TOOL

D

J.

J.

ANAL YTICAL MODELING OF MICRO END-MILLING FORCES WITH EDGE RADIUS AND MATERIAL STRENGTHENING EFFECTSD Siddharth Rao and M. S. Shunmugam

GREEN MACHINING ORIENTED TO DIMINISH DENSITY

GRADIENT FOR MINIMIZATION OF DISTORTION lN ADVANCED CERAIVIICSD Gill Bukvic, Luiz Eduardo de Angelo Sanchez,

Carlos Alberto Fortulan, A. A. Fiocchi, and Ioan Demitrius Marinescu BEVELING OF QUARTZ CRYSTAL BLANKS: AN EXPERIMENTAL STUDY D Chensong Dong

ANAL YTICAL MODELING OF THE EFFECTOF THE TOOL FLANK WEAR WIDTH ON THE RESIDUAL STRESS DISTRIBUTION D Lin Yan, Wenyu Yang, Hongping Jin, and Zhiguang Wang

CORRELATION-BASED ESTIMATION OF CUTTING FORCE COEFFICIENTS FOR BALL-END MILLING D Jaspreet Dhupia and Irving Girsang

SHORT COMMUNICATION

OPTIMALMQL AND CUTTINGCONDITIONSDETERMINATION FOR DESIRED SURFACE ROUGHNESS lN TURNING OF BRASS USING GENETIC ALGORITHMS D V. N. Gaitonde, S. R. Karnik, and J. Paulo Davim

2012

157

173

189

205

228

247

265

287

304

@ Taylor & Francis

10910344(2012)16(2)

----