HAL Id: hal-00881904
https://hal.archives-ouvertes.fr/hal-00881904
Submitted on 1 Jan 2002
HAL is a multi-disciplinary open access archive for the deposit and dissemination of sci- entific research documents, whether they are pub- lished or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers.
L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d’enseignement et de recherche français ou étrangers, des laboratoires publics ou privés.
Clonal variation of wood density record of cambium reaction to water deficit in Picea abies (L.) Karst
Philippe Rozenberg, Julien van Loo, Bjorn Hannrup, Michael Grabner
To cite this version:
Philippe Rozenberg, Julien van Loo, Bjorn Hannrup, Michael Grabner. Clonal variation of wood den-
sity record of cambium reaction to water deficit in Picea abies (L.) Karst. Annals of Forest Science,
Springer Nature (since 2011)/EDP Science (until 2010), 2002, 59 (5-6), pp.533-540. �10.1051/for-
est:2002038�. �hal-00881904�
Annals of Forest Science Instructions to authors
The journal Annals of Forest Science pub- lishes original articles, review articles, short notes and proceedings of scientific meetings in English and in French. They must be previ- ously unpublished and should not be under consideration elsewhere.
For submission address manuscripts to:
Annals of Forest Science, Editorial Secretary, Centre de Nancy, INRA, 54280 Champenoux, France (e-mail: [email protected]). For USA and Canada: Pr. David E. Hibbs, Annals of Forest Science: Peavy Hall 154, Oregon State University, Corvallis, Oregon, 97331, USA (e-mail: [email protected]).
GENERAL PRESENTATION
Three complete sets of the manuscript must be submitted. The manuscript should be typed double-spaced with margine of at least 3.5 cm at top, bottom and sides for editor’s markings. The fines should be numbered.
The manuscript should be arranged as fol- lows: title page, abstract in the language of the article, title and abstract in the other lan- guage (in English, if the article is written in French and vice versa), introduction, materi- als and methods, results, discussion, ac- knowledgments, references, figure legends, tables, figures.
Papers to be published as a “note” should not be longer than 9 pages, including figures and tables.
After the article has been accepted for publi- cation, authors are encouraged to forward the revised manuscript on disk to the editor (RTF format for the text, and, if possible, figures should be saved in EPS, TIFF or JPEG for- mats using standard fonts and high resolu- tion).
Title page
The title page should include the following:
the title of the article, the surname and fore- names (in full) of each author, the depart- ment and institution where the study was carried out, telephone and fax numbers and e-mail address of the corresponding author (this author being identified by an asterisk), a short title (running head) of no more than 45 characters, including spaces.
Abstract
The abstract (less than 150 words) should be in a form suitable for abstracting services.
Paragraphs, footnotes, references, cross-ref- erences to figures and tables and undefined abbreviations should be avoided.
Keywords
Up to five keywords should be supplied.
Please try to avoid the plural form. Keywords
may be taken from the title, abstract or text.
The plural form and uppercase letters should be avoided. Keywords should be written in bold lowercase letters, separated by slashes.
References
In the reference list, the references should ap- pear in alphabetical order, preceded by an Arabic numeral enclosed in square brackets.
The authors’ names are listed in alphabetical order, and in chronological order for each au- thor. If there is more than one author, the or- der is as follows: publications of a single author in chronological order; publications of the same author with one co-author in al- phabetical order of the second author, and in chronological order; publications of the au- thor with more than one co-author in chrono- logical order. The references are cited in the text by the corresponding number enclosed in square brackets. All entries in the refer- ence list must correspond to references in the text and vice versa. When authors are cited in the text (within a phrase and not just between brackets), the spelling of the authors’ names must be exactly the same as in the reference list. The titles of journals should be abbrevi- ated according to the rules of Biosciences In- formation Service (Biosis) or those of the Liste d’abréviations de mots des titres de publications en série (conforming to ISO 4, Centre international de ISSN, Paris). Words for which no abbreviation is given should be written in full. Examples are given below of the layout and punctuation to be used in the references:
Article:
[1] Halter M.R., Chanway C.P., Growth and root morphology of planted and naturally-re- generated Douglas fir and Logepople pine, Ann. Sci. For. 50 (1993) 71−77.
Book:
[2] Kramer P.J., Koslowski T.T., Physiology of Trees, McGraw-Hill, New York, 1960.
Article in a book:
[4] Halldin S., Gripp H., Perttu K., Model for energy exchange of a pine forest canopy, in:
Halldin S. (Ed.), Comparison of Forest Water and Energy Exchange Models, Elsevier, Am- sterdam, 1979, pp. 59−75.
Illustrations (figures and tables) Illustrations (one original and two good copies) should be numbered in Arabic nu- merals for figures and Roman numerals for tables, and should be referred to in the text by their number (figure 1, table I). Lettering (symbole, numbers, etc.) should not differ
from figure to figure and should be of suffi- cient size to remain legible after reduction (letters 1–2 mm high after reduction to either one or two column format). Figures should be presented in the form of fine drawings on drawing or tracing paper or as sharp glossy prints. Half-tones should contain good con- trast and should be originals (i.e. not already reproduced); line drawing should have a white background. Photographs should be presented in the form of plates to be repro- duced without reduction (maximum size 17×21 cm or 17 ×23 cm for ‘full page’
illustrations. The lettering (height 1–2 mm) should not be placed any closer to the edges than 1 cm. The figure captions should be ex- plicit so that the illustrations are comprehen- sible without reference to the text, and should be presented together on a separate sheet at the end of the paper. In the paper version of the journal, figures are in black and white (for colour, authors should make a contri- bution, prices on request), but they appear in colour in the electronic version. Tables should not exceed 84 characters per line (140 if in landscape format). The title of each table should be written above the corresponding table. Figures and tables published elsewhere cannot be accepted without the prior written consent of the publisher and the author(s).
The Editorial Board maintains the option of returning, before evaluation, manuscripts to authors who do not comply with these recommandations. The author is advised to keep one manuscript and a set of figures.
PROOFS AND REPRINTS
Proofs will be sent to the author indicated on the title page. They should be carefully cor- rected and returned to the publisher within 48 hours of reception. If this period is ex- ceeded, the galleys will be proofed only by the editorial staff of the publishing house and printed without the author’s corrections.
Should substantiel changes in the original manuscript be requested, they will be made at the author’s expense. The PDF file of the article will be provided free of charge. An order form for reprints will accompany the proofs.
COPYRIGHT
The author returns the signed transfer of copyright and publishing agreement form with the corrected proofs.
As soon as the article is published, the author is considered to have transferred his rights to the publisher. Requests for reproduction should be sent to the latter.
