Vs = ± 15V. TA = 25°C. unless otherwise noted
LTl 002AM/LTl 002AC LT1 002M/LTl 002C
SYMBOL PARAMETER CONDITIONS MIN TYP MAX MIN TYP MAX UNITS
Vos Input Offset Voltage Note 1 20 60 25 100 I'V
!;.Vos Long Term Input Offset Voltage
!;. Time Stability Notes 2 and 3 0.3 1.5 0.4 2.0 "V/month
los Input Offset Current 0.3 2.8 0.4 4.2 nA
Ie Input Bias Current +0.6 +3.0 +0.7 +4.5 nA
en Input Noise Voltage 0.1Hz to 10Hz (Note 2) 0.35 0.7 0.38 0.75 I'V,.p
en Input Noise Voltage Density fo ~ 10Hz (Note 5) 10.3 20,0 10.5 20.0
nvV;';;
fo ~ 1000Hz (Note 2) 9.6 11.5 9.8 12.0
AVOL Large Signal Voltage Gain RL ;;> 2k!l, Vo ~ ± 12V 400 800 350 800
Vim V
RL ;;> 1k!l, Vo ~ ± 10V 250 500 220 500
CMRR Common Mode Rejection Ratio VCM ~ + 13V 110 126 110 126 dB
PSRR Power Supply Rejection Ratio Vs ~ ±3Vto ±18V 108 123 105 123 dB
Rin Input Resistance Differential Mode Note 4 20 100 13 80 M!l
Input Voltage Range ±13 ±14 ±13 ±14 V
Your Maximum Output Voltage Swing RL ;;> 2k!l ±13 ±14 ±13 ± 14 V
RL;;> 1k!l ± 12 ± 13.5 ±12 ± 13.5
SR Slew Rate RL ;;> 2k!l (Note 4) 0.1 0.25 0.1 0.25 VII'S
GBW Gain Bandwidth Product Note 4 0.4 0.8 0.4 0.8 MHz
Pd Power Dissipation per amplifier No load No load, V, ~ ± 3V 46 4 75 7 48 4 85 8 mW
ELECTRICAL CHARACTERISTICS, InDIVIDUAL AmPLIFIERS
Vs = ± 15V, -55°C ~ TA ~ 125°C, unless otherwise noted
SYMBOL PARAMETER CONOITIONS
Vos Input Offset Voltage Note 1 ::'Vos Average Input Offset Voltage Drift ::, Temp
los Input Offset Current IB Input Bias Current
AVOL Large Signal Voltage Gain RL ;" 2kll, Va ~ ± 10V CMRR Common Mode Rejection Ratio VCM ~ ± 13V PSRR Power Supply Rejection Ratio Vs ~ ± 3V to ± 18V
Input Voltage Range
Your Output Voltage Swing RL ;" 2kll
Pd Power Dissipation No load
per amplifier
Vs = ± 15V, DoC ~ TA ~ 70°C, unless otherwise noted
SYMBOL PARAMETER CONOITIONS
Vos Input Offset Voltage Note 1 ::'Vos Average Input Offset Voltage Drift ::, Temp
los Input Offset Current IB Input Bias Current
AVOL large Sfgnal Voltage Gain RL ;" 2kll, Va ~ ± 10V CMRR Common Mode Rejection Ratio VCM ~ ± 13V PSRR Power Supply Rejection Ratio Vs ~ ± 3V to ± 18V
Input Voltage Range
Your Output Voltage Swing RL ;" 2kll
Pd Power Dissipation No load
per amplifier
The. denotes the specifications which apply over the full operating temperature range.
For MIL-STD components, please refer to LTC 883C data sheet for test listing and parameters.
Nole 1: Offset voltage measured with high speed test equipment, approximately 1 second after power is applied.
No Ie 2: This parameter is tested on a sample basis only.
Note 3: Long Term Input Offset Voltage Stability refers to the averaged trend line of Vos versus Time over extended periods after the first 30 days of operation. Excluding the initial hour of operation, changes in Vos during the first 30 operating days are typically 2.5/l V.
LTlOO2AM LTlOO2M
MIN TYP MAX MIN TYP MAX
LTl 002AC LTlOO2C
MIN TYP MAX MIN TYP MAX would sacrifice the advantages of the power supply rejection ratio matching). The V - supply terminals are both connected to the
mATCHinG CHARACTERISTICS
at Vs = ± 15V. TA = 25°C. untess otherwise notedLTI 002AMI AC LTlO02M/C
SYMBOL PARAMETER CONDITIONS MIN TYP MAX MIN TYP MAX UNITS
Input Offset Voltage Match
-
15 40-
25 80 /iVIe + Average Non-Inverting Bias
Current - +0.6 +3.5
-
+0.7 +4.8 nAlos + Non-Inverting Offset Current
-
0.6 3.5-
0.7 6.0 nAlos Inverting Offset Current
-
0.6 3.5-
0.7 6.0 nA.:.CMRR Common Mode Rejection Ratio
Match VCM = ± 13V 110 132 - 108 132
-
dB.:.PSRR Power Supply Rejection Ratio
Match Vs = +3Vto +18V 108 130
-
102 128-
dBChannel Separation f .. 10Hz (Note 4) 132 148
-
130 146-
dBmATCHinG CHARACTERISTICS
at Vs = ± 15V. -55°C.;;; TA .;;; 125°C. unless otherwise notedLTlO02AM LTlO02M
SYMBOL PARAMETER CONDITIONS MIN TYP MAX MIN TYP MAX UNITS
Input Offset Voltage Match
•
- 50 140-
60 230 !'VInput Offset Voltage Tracking
•
- 0.3 1.0-
0.4 1.5 !'V/'CIe + Average Non-Inverting Bias
Current
•
- + 1.5 +6.0-
+1.8 + 10.0 nAlos + Non-Inverting Offset Current
•
- 1.5 6.5-
1.8 12.0 nAlos Inverting Offset Current
•
- 1.5 6.5 - 1.8 12.0 nA.:.CMRR Common Mode Rejection Ratio
Match VCM = ± 13V
•
106 126-
102 124 - dB.:.PSRR Power Supply Rejection RatiO
Match Vs = ±3Vto ±18V
•
102 122-
94 120 - dBmATCHinG CHARACTERISTICS
at Vs = ± 15V. DOC.;;; TA .;;; 7DoC. unless otherwise notedLT1002AC LT1002C
SYMBOL PARAMETER CONDITIONS MIN TYP MAX MIN TYP MAX UNITS
Input Offset Voltage Match
• -
30 85 - 45 150 /iVInput Offset Voltage Tracking
•
- 0.3 1.0 - 0.4 1.5 !'vrcIe + Average Non-Inverting Bias
Current
•
- ±1.0 ±4.5 - ±1.2 ±7.0 nAlos + Non-Inverting Offset Current
• -
1.0 5.0 - 1.2 8.5 nAlos Inverting Offset Current
•
- 1.0 5.0 - 1.2 8.5 nA.:.CMRR Common Mode Rejection Ratio
Match VCM = ± 13V
•
108 130 - 105 128-
dB.:.PSRR Power Supply Rejection RatiO
Match Vs = ± 3V to ± 18V
•
105 126 - 98 124 - dBTYPICAL PERFORmAnCE CHARACTERISTICS
Distribution of Offset Voltage of Individual Amplifiers
INPUT OFFSET VOLTAGE (,V)
Offset Voltage Drift with Temperature of Six Representative Units
LTl0~
Tl002AM
...-
~~-
..,... ~ ...-~~\OO2~ ~,... ...
...r--
... ~1002MKT1002M i""'--o
-50 -25 0 25 50 75 100 125
10
-10
TEMPERATURE (OC)
Long Term Stability of Four Representative Units
r
V'
t::::~
o
TIME (MONTHSI
Distribution of Offset Voltage Drift with Temperature
(Individual Amplifiers)
70 r---;---,----,---,---,
60 r---t--+-+--t---t--j
50 r---t--t--f"""'~t---t--j 40 r---t--t---J....,.""",!+--t--j
30 1---+--++,..,;
20 f--+-F,
10
o
'----="--"'--1.2 -0.8 -0.4 +0.4 +0.8 + 1.2 INPUT OFFSET VOLTAGE DRIFT
WITH TEMPERATURE (,V/0C)
Offset Voltage Tracking with Temperature of Six Representative Units
100 r--r-,----,---;----,--.,--.,.-".,-,
Distribution of Offset Voltage Match Drift with Temperature
20 f---+---+' 15 f---+--±
-1.2 -0.8 -0.4 0 +0.4 +0.8 + 1.2 OFFSET VOLTAGE MATCH DRIFT
WITH TEMPERATURE (,V/OC)
Warm-Up Drift
(
V
VS~ ,15V TA - 25°C N 14 PLASTIC PACKAGE
)14 HERM~TIC DIP ~ACKAGE
TIME AFTER POWER ON -BOTH AMPLIFIERS (MINUTES)
Noise Spectrum
TYPICAL PERFORmAnCE CHARACTERISTICS
Matching and Individual Amplifier Input Bias Current
Bias and Offset Currents vs Temperature Over the Common Mode Range
TEMPERATURE ('C)
Open Loop Voltage Gain vs Temperature
1 ; \
TEMPERATURE (0G)
Open Loop Gain Mismatch vs Frequency
OUTPUT A - OUTPUT 8 7\;-':(O"'U=TP"'U=T-:-A ""'+--:O"'U:::TP"'U=-T =-8) X 100%
10 100 lk 10k lOOk
DErCE WITH POSITIVE INPUT CURR1ENT
, i I
I 1
Vs ~ ,15V 1 TA ~ 25°C DEVICE WITH NEGATIVE INPUT CURRENT
L . . ; . -COMMON·MODE
INPUT RESISTANCE ~ 02f~A ~ 2BOG n
15 -10 -5 10 15
COMMON·MODE INPUT VOLTAGE
Open Loop Voltage Gain
Closed Loop Output Impedance
100 li-I-J:::::::;::~
Input Bias Current vs.
Differential Input Voltage
Vs ~±15V j
± DIFFERENTIAL INPUT (VOLTS)
Gain, Phase Shift vs. Frequency
Power Supply Rejection and PSRR Match vs Frequency
TYPICAL PERFORmAnCE CHARACTERISTICS
Channel Separation vs Frequency
160
Supply Current vs. Supply Voltage For Each Amplifier
2.0 I---t---+--'~-t---b-"b--I
0.5
I~~---'··-'--,---+-·3 ,6 ,9 ,12 ,15 ·18 ·21 SUPPLY VOLTAGE (V)
Small Signal Transient Response
20mV 2/LS:Iiiii CMRR Match vs Frequency
I i VS~I'15V
Large Signal Transient Response
!II - '-'-iii
Voltage Follower Overshoot vs Capacitive Load
CAPACITIVE LOAD (PICOfARADS)
iii ::;
Common Mode Limit vs Temperature
TEMPERATURE 'C
Maximum Undistorted
fREQUENCY (kHz)
Small Signal Transient Response
20 mV r:I 2/LS.
I!! !!
::::;; I'~ ;';;=:1AV ~ + 1, CL ~ 1000pf