Int. J. Machining and Machinability of Materials, Vol. 4, Nos. 2/3, 2008
~ FORM Contents
ED) SPECIAL ISSUE: SURFACE INTEGRITY lN MACHINING PROCESSES
Guest Editor: Prof. J. Rech
'aterials is published
; user only) € 735
us user only) € 1,025
uilding Il,
zerland. 158
'able ta:
) f Sterling at the
181
195
217
Machining and
f... 237
...
... 252
""""""""""""""'"
...
...
... 275 ...
...
129 Editorial Joël Rech
133 Polish-mirror finish surfaces obtained by high precision turning Alexis Gautier, Hatem Khanfir, Philippe Revel and René-Yves Fillit 148 A numerical study of phase transformation during grinding
Alexandre Brosse, Hedi Hamdi and Jean Michel Bergheau Surface profile prediction and analysis for turning process Chen Lu and Jean-Philippe Costes
Residual stress analysis in Inconel 718 milled turbine disk Mario Lavella, Teresa Berruti and Enrica Bosco
Effect of shot peening parameters on the surface integrity of 316L material
S.B. Mahagaonkar, P.K. Brahmankar and C.Y. Seemikeri
Experimental investigation to predict the condition of cutting tool by surface texture analysis of images of machined surfaces based on amplitude parameters
B.S. Prasad and M.M.M. Sarcar
Some studies on design and performance analysis of a new low plasticity burnishing tool
C.Y. Seemikeri, P.K. Brahmankar and S.B. Mahagaonkar
Effect of SiC powder-suspended dielectric fluid on the surface finish of 6061Al/AhO3P/20p composites during electric discharge machining Shankar Singh, Sachin Maheshwari and Poom Chandra Pandey>
A new approach for the modelling of residual stresses induced by turning of 316L austenitic stainless steel
Frédéric Valiorgue, Joel Rech, Hedi Hamdi, Philippe Gilles and Jean Michel Bergheau
"""""""""""""
sterling equivalent to
...
...
fions
