• Aucun résultat trouvé

One step synthesis of core@shell SiGe@Si nanoparticles and their use as active material in high capacity anodes for Li-ion batteries

N/A
N/A
Protected

Academic year: 2021

Partager "One step synthesis of core@shell SiGe@Si nanoparticles and their use as active material in high capacity anodes for Li-ion batteries"

Copied!
3
0
0

Texte intégral

(1)

HAL Id: cea-02329299

https://hal-cea.archives-ouvertes.fr/cea-02329299

Submitted on 23 Oct 2019

HAL is a multi-disciplinary open access archive for the deposit and dissemination of sci- entific research documents, whether they are pub- lished or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers.

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d’enseignement et de recherche français ou étrangers, des laboratoires publics ou privés.

One step synthesis of core@shell SiGe@Si nanoparticles and their use as active material in high capacity anodes

for Li-ion batteries

Antoine Desrues, John Alper, Florent Boismain, Pierre-Eugène Coulon, Adrien Soloy, Cédric Haon, Nathalie Herlin-Boime

To cite this version:

Antoine Desrues, John Alper, Florent Boismain, Pierre-Eugène Coulon, Adrien Soloy, et al.. One step synthesis of core@shell SiGe@Si nanoparticles and their use as active material in high capacity anodes for Li-ion batteries. Lithium Battery Discussions ”Electrode Materials” (LiBD-9), Sep 2019, Arcachon, France. �cea-02329299�

(2)

LiBD-9 2019 – Arcachon, France September 15-20, 2019

One step synthesis of core@shell SiGe@Si nanoparticles and their use as active material in high capacity anodes for Li-ion batteries

Antoine Desrues1, John P. Alper1,2, Florent Boismain1, Pierre-Eugène Coulon3, Adrien Soloy1, Cédric Haon2, Nathalie Herlin-Boime1

1 NIMBE, UMR 3685 CEA, CNRS, Université Paris-Saclay, CEA-Saclay, F-91191 Gif-sur-Yvette Cedex 2 Université Grenoble Alpes, CEA-Liten, F-38054 Grenoble, France

3 LSI, CNRS, CEA-DRF-IRAMIS, Ecole Polytechnique, Université Paris-Saclay, Palaiseau, France

In the frame of energy transition, silicon is a material of interest to develop Li-ion batteries with increased energy density. Nevertheless, the important volume change upon cycling (280 %) and reactivity towards electrolytes lead to rapid degradation of performances. Designing silicon-germanium structures is an efficient strategy to obtain stable performances of Li-ion batteries anodes. The synergetic effect of alloying silicon and germanium was demonstrated by Duveau et al [1], using micrometric particles obtained by ball-milling. The stability of the alloys was better than the stability of pure silicon and its capacity was higher than the capacity of pure germanium.

This paper presents the one step synthesis of nanoparticles of Si-Ge alloys by laser pyrolysis using silane and germane as gaseous precursors. The average chemical composition of the powders (Si/Ge ratio) appears well correlated with the silane to germane ratio introduced in the reactor. Using STEM-EDX, an original SiGe@Si core@shell heterostructure is observed on these particles (fig. 1); the alloy is surrounded by a silicon shell. Using in-situ temperature measurements, we found that the temperature in the reaction zone is above the stability zone of the alloy and favors migration of chemical species to the surface.

Varying the ratio between precursor gases led to the synthesis of various Si100-xGex heterostructures with x = 0, 20, 47, 77, and 100. X-Ray diffractions studies enlightened the proportions of each phase and their compositions, in good correlation with EDX measurements.

All the three alloy compositions were cycled at C/5 in coin cells vs lithium. The electrochemical performances (fig. 2) outperform materials with similar compositions already published [1]. The capacity of all alloy compositions is higher when compared to germanium, whereas stability and coulombic efficiency upon cycling is better when compared to silicon. The best performances were obtained for Si53Ge47 with a reversible capacity of 1685 mAh.g-1 after 60 cycles.

[1] Duveau, D. et al., Chemistry of Materials 2015, 27 (9), 3226-3233

Figure 1: STEM and STEM-EDX pictures of two SixGe1-x alloys: Si80Ge20 (left column), Si53Ge47 (right

column), green color corresponds to Ge atoms while orange color corresponds to silicon.

(3)

LiBD-9 2019 – Arcachon, France September 15-20, 2019

Figure 2: (a) Galvanostatic cycling performances of the alloys compared to silicon and germanium. (b) coulombic efficiencies of mentioned materials.

Références

Documents relatifs

In contrast, during the search task, neurons began finding the target later than in pop-out, just before the saccade, and in the reverse order: the frontal areas (dlPFC and FEF)

The appealing ability to perform a room temperature synthesis of amorphous silicon and the need for better understanding of the reaction pathways, drive us to study the reactivity

Three-dimensional composites Li 2 TiO 3 /graphene (LTO/Gr) and Li 2 TiO 3 /carbon nanotube (LTO/CNTs) were synthesized by solid-state reaction for application as anode

Silicon Core Carbon Shell Nanoparticles By Scalable Laser Pyrolysis for Li-Ion Alloy Anodes – Material Synthesis and Performance Characterization.. Functional Energy Materials,

The influence of the carbon coating on electrochemical performances was studied in coin cells in operando conditions by using electrochemical impedance spectroscopy (EIS) as well

In this paper, using this technique, an improved stability of carbon coated silicon particles will be demonstrated by comparison to

In order to revalue the waste from the extraction of oil of Opuntia ficus‐indica seeds, in this study cakes resulting from the pressing were macerated in ethanol and then

Pour contribuer à l’amélioration de la stratégie du TGRN, 487 communautés gestionnaires de ressources naturelles, issues de 17 régions de Madagascar, ont constitué le réseau