• Aucun résultat trouvé

Microstructural Study of Thin Films CuFeObtained by ThermalEvaporation ofNanostructured Milled Powde

N/A
N/A
Protected

Academic year: 2021

Partager "Microstructural Study of Thin Films CuFeObtained by ThermalEvaporation ofNanostructured Milled Powde"

Copied!
1
0
0

Texte intégral

(1)

Journal of Nano Research

Volume 47, Issue 1, 2017, Pages 71-78

Microstructural Study of Thin Films CuFe Obtained by ThermalEvaporation of

Nanostructured Milled Powde

H. Mechri, A. Haddad, M. Zergoug, M. Azzaz

Abstract: Commercial copper and iron powders were used as starting materials. These powderswere mechanically alloyed to obtain Cu(100-x) Fex supersaturated mixture. The milling duration waschosen in such a way as to obtain a nanostructured mixture and to form a supersaturated solidsolution of CuFe; the powder mixture was used to deposit CuFe on a glass substrate.The elaboration of our films has been carried out using thermal evaporation process (physical vapordeposition) under 1 × 10-6 mbar vacuum from an electrically heated tungsten boat, using thesupersaturated solid solution Cu(100-x) Fex powder obtained by mechanical alloying.

The filmsdeposition has been done on glass substrates. In this study, we present the composition effect on thestructural and magnetic proprieties of Cu(100-x) Fex powder and thin films. The chemicalcomposition, structural and magnetic proprieties of milled powders and thin films were examinedby SEM, TEM, XRD, XRF and VSM.

Keywords : thin film, CuFe Solid Solution, microstructure, DRX, MET, VSM

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

According to the interpreters, the style represents one side of the Quranic miracle that is why these interpretations applied to the Quranic style prodigy was a practical example

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The system is based on a transport- chemistry model driven by ECMWF meteorological fore- casts, and assimilates near-real time total column ozone mea- surements of the

(ii) fissures observed at section I (Figure 4), located at the upper spherical pole of the

The elaboration of our films has been carried out using thermal evaporation process (physical vapor deposition) under 1 × 10-6 mbar vacuum from an electrically heated tungsten

The elaboration of our films has been carried out using thermal evaporation process (physical vapor deposition) under 1 × 10 -6 mbar vacuum from an electrically heated tungsten boat,

materials by a linearization process Indeed, a change in magnetic field is reported on the stress-strain characteristics and induces a mechanical residual coercitive stress, this

We study a binary mixture of long thin rodlike particles using an idealised model in which the rods have restricted orientations and the two types of rod differ only in