• Aucun résultat trouvé

Grain size influence on ultrasonic velocities andattenuation

N/A
N/A
Protected

Academic year: 2021

Partager "Grain size influence on ultrasonic velocities andattenuation"

Copied!
1
0
0

Texte intégral

(1)

NDT and E International

Volume 36, Issue 1, 2003, Pages 1-5

Grain size influence on ultrasonic velocities and attenuation

A. Badidi Bouda, S. Lebaili, A. Benchaala

Abstract: During the last two decades, ultrasonic testing was developed as an efficient tool for materials characterization.

Acoustical waves by their passage through materials, carry out a multitude of information contained in the signal on the mechanical and physical properties of the material under inspection. In this paper, an experimental study on steel samples has been performed to study the evolution of some ultrasonic parameters such as wave velocities and attenuation coefficients as function of the steel grains size. The experimental results obtained are discussed and analyzed in order to develop an ultrasonic non-destructive technique to grains size determination.

Keywords : Ultrasonic, Grain Size, Velocity, Attenuation, Scattering

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

Although they saw no dislocation effects in the purest crystals, they did see changes in both attenuation and sound velocity when the impure crystals were cooled below their

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The effect of dislocation damping in pure aluminium has been observed by in situ deformation in a scanning acoustic microscope operating at 730MHz.. Another poly-

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Because the temperature of the Bordoni peak shifts with deformation, especially for low values of deformation, we have compared our results with those of ~ a s s a n l ~ at

Abstract: In this paper, an experimental technique has been developed to measure velocities and attenuation of ultrasonic waves through a steel with a variable hardness.. A

Figure 8 shows the variation of central frequency versus the load bending. With increasing the bending force, the central frequency increase for longitudinal waves