• Aucun résultat trouvé

The characterisation of solids by adsorption and immersion techniques and by AFM/STM

N/A
N/A
Protected

Academic year: 2022

Partager "The characterisation of solids by adsorption and immersion techniques and by AFM/STM"

Copied!
9
0
0

Texte intégral

(1)

Published in Journal of the European Ceramic Society 18, issue 9, 1177-1185, 1998

which should be used for any reference to this work 1

(2)

2

(3)

3

(4)

4

(5)

5

(6)

6

(7)

7

(8)

8

(9)

9

Références

Documents relatifs

Based on multivariate analysis to evaluate the relevance of the new serological tests as compared with clinical groups, we confirm that Latex IgM CSF, cheap and easy to perform

These results are invaluable in determining the anticorrosive protection of metallic structures exposed at corrosion problems, in particular, in the installation of duplex

The introduction of a backward error estimate in the solution of bound-constrained nonlinear optimization will provide, at each step of the algorithm, a measure of the perturbation

Much work in organic SIMS is devoted to interpreting fingerprint spectra (low mass region, up to m/z of 200) in order to have a better understanding of

It must be underlined, that presently the best contrast powder method available to characterise cation distribution of a bicationic zeolite under working conditions (temperature

Measurements are carried out on gels of increasing polymer concentration in a wide frequency range.. A model based on fractional derivatives is successfully used, covering the

as q4S(q) ~erslts q. The curves exhibit classical features: I) an asymptotic Porod's plateau proportional to the specific area c~L(c~ surfactant concentration, L area per polar

Le tableau fig. 21 résume une comparaison globale entre les six stations étudiées. On remarque tout d'abord le petit nombre d'espèces appartenant à la macrofaune