• Aucun résultat trouvé

Feature Extraction and SOM for Bearing FaultDiagnosis

N/A
N/A
Protected

Academic year: 2021

Partager "Feature Extraction and SOM for Bearing FaultDiagnosis"

Copied!
1
0
0

Texte intégral

(1)

International Conference on NDT and Material Industry and Alloys (IC-WNDT-MI'14).

2014

Feature Extraction and SOM for Bearing Fault Diagnosis

Tawfik THELAIDJIA, Abdelkrim Moussaoui, Salah CHENIKHER, Amar BOUTAGHANE, Sami KAHLA

Abstract : In this paper a method for fault diagnosis of rolling bearings is presented. It consists of two parts: vibration signal feature extraction and condition classification. The aim of the first step is the extraction of the relevant parameters; the proposed technique consists of preprocessing the bearing fault vibration signal using a combination of the signal’s Kurtosis and discrete wavelet transform (DWT). The Self-organization Map (SOM) is used to accomplish the classification step and automate the fault diagnosis procedure. The results have shown feasibility and effectiveness of the proposed approach.

Keywords : Condition monitoring, Discrete wavelet transform, Fault Diagnosis, Kurtosis, Roller Bearing, Rotating machines, Self-organization Map, Vibration measurement.

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

But I disagree with him that this norm is more basic than the norm of knowledge (2001: 289- 90) 15 The objection is well formulated by David 2001: “Although knowledge is certainly

Quanti fication of epidermal DR5:GFP reflux signals (Figure 2F; see Supplemental Figure 1 online) con firmed slightly reduced basipetal re flux for twd1 (Bailly et al., 2008)

The proposed algorithm has been tested in some critical scenarios, e.g., for highly correlated sources, and/or for closely spaced sources, the results have shown that the variance

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

This section presents the feature extraction methodology proposed in the context of this paper. The extracted features are able to quantify the degree of anomaly of each MOAS

The aim of the first step is the extraction of the relevant parameters; the proposed technique consists of preprocessing the bearing fault vibration signal using

In this paper, feature extraction from faulty bearing vibration signals is performed by a combination of signal's time-varying statistical parameters and features obtained through

In this paper, feature extraction from faulty bearing vibration signals is performed by a combination of signal's time-varying statistical parameters and features