• Aucun résultat trouvé

NONDESTRUCTIVE EVALUATION OF THECARBON CONTENT IN STEEL

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "NONDESTRUCTIVE EVALUATION OF THECARBON CONTENT IN STEEL"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

Journal of Applied Mechanics and Technical Physics

Volume Vol. 55,, Issue No. 3, 2014, Pages 0-0

NONDESTRUCTIVE EVALUATION OF THE CARBON CONTENT IN STEEL

A. Badidi Bouda, H. Belkhelfa, W. Djerir, and R. Halimi

Abstract: The aim of this work is to propose an experimental method to evaluate the steel carbon content by ultrasound. The sample is immersed in a water tank in order to analyze it under various incidences of sound waves. Longitudinal wave velocities are measured by immersion by using a 5-MHz frequency probe. Transverse wave velocities are measured in a contact mode by using a 4-MHz transverse wave transducer. The attenuation coefficients of ultrasonic longitudinal and transverse waves are deduced from three successive basic echoes through the sample. The effects of some heat treatments on ultrasonic parameters are also studied. The measurement of ultrasonic parameters in steel offers an interesting possibility of tracing the carbon content and, at the same time, provides information on the steel structure and its elasticity

Keywords : carbon content, steel, ultrasonic waves.

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Télécharger maintenant ( PDF - 1 Page - 7.64 KB )

Documents relatifs

Degassing patterns of Tungurahua volcano (Ecuador) during the 1999–2006 eruptive period, inferred from remote spectroscopic measurements of SO2 emissions

degassing modes are controlled by variations in the magma ascent rate and conduit permeability, which in fluences gas segregation processes leading to passive emissions; or to

The transcriptional landscape of polyploid wheat

Genes from syntenic triads in the balanced category were expressed across a wider range of tissues and had higher absolute transcript abundance, on a per-subgenome basis (12.2

Camera–projector matching using unstructured video

Table 2 shows the number of inliers found by our method and by SIFT (RANSAC has been used to filter out outliers) for the live band and corridor sequences projected on a plane at

Ex vivo assays of CEM cells cultured and treated in the three dimensional cultures

Therefore, the low binding effects measured using cells’ viability was specific to Herceptin or anti-HER-2 (clone CB-11) interactions with HER-2.. receptor and not due to

Multi-scale Planar Segments Extraction from Point Clouds

The output graph is a compact abstraction of the input cloud into multiple, possibly overlapping, segments, each relevant at a certain scale.. The edges of the graph connect nodes

EFFECT OF ULTRASONIC VIBRATION ON THE METALLURGICAL PROPERTIES OF STEEL

Therefore we have made a series of experiments in order to clarify the effect of ultrasonic vibration on the metallurgical and mechanical properties of low carbon aluminwn-

HISTORY OF THE HARDENING OF STEEL : SCIENCE AND TECHNOLOGY

About 1900 Osmond believed beta-iron was the cause of the hardening since the normal transformation to alfa- iron was prevented by the sudden cooling.. In 1895 both theories

Use of Hydrogen in the Steel Industry

Abstract : The use of hydrogen as a clean and storable energy is involved in the substitution of coking coal from natural gas for the reduction of iron oxides by the reduction of