(1)Copyright ©
3
0
0
Texte intégral
(2) Copyright © NRC 1941 - 2019 World Rights Reserved © CNRC 1941-2019 Droits réservés pour tous pays. Page. Reference. Correction. 1. 1.2.1.2.. In the second line of the definition of load-sharing system, change "mutally" to read "mutually". Delete the following: "wt ..............weight" "p .............. mass density, kg/m3".. 3. Table 2.2.1.A.. Delete title and substitute "Minimum Specified Live Loads Due to Use". In the second line, italicize "live load". Delete the first line and substitute:. (4) Where an area serves as a place for processing, or for loading or unloading of vehicles, the minimum In the third line beneath the formula, change "Sentence" to read "Article". In the second line, italicize "foundation". Italicize "load-sharing systems". In the fourth line, change "9.10.15." to read "9.10.14." In the first line, italicize "partition". 15. Appendix A 2.2.1.10.(2). In the tenth line, delete ",Hs,", In the eleventh line, add "Hs," after "occur,".. 18. Appendix A 2.2.1.13.. In the fourth line, change "V = UK" to read "V = L/k". After the description of $, add: =. 20-22. Appendix A Table 3. angle of friction of material on bin wall".. In the title, change "Apparent" to read "Bulk..
(3) Copyright © NRC 1941 - 2019 World Rights Reserved © CNRC 1941-2019 Droits réservés pour tous pays. Page. Reference. Correction. 22. Appendix A Note 2 to Table 3. In the second and fifth lines, change "apparent" to read "bulk. In the second, fourth and fifth lines, change " D to read " p ".. 23. 27. change "Tan $. Appendix A. In the description of @. 2.2.1.13.. read "tan. Appendix A 3.1.5.1.. In the second line of Note (I), change "Article 9.10.4.1." to read "Article 9.10.3.1.". el".. 1,. to.
(4)
Documents relatifs
Therefore, they form part of the basic climatic information needed for building design and are given in Chapter 1 of this Supplement in the Table "Design Data for Selected Locations
Supplement to the National Building Code of Canada f 990 Fourth Revisions and Errata Issued by the Canadian Commission on Building and Fire Codes National Research Council of
Plastic Pipe, Fittings and Solvent Cement Used Above Ground 1 Plastic pipe, fittings and solvent cement used inside or under a building in a drainage or venting system shall conform
Test Procedures 1 When Measure G is used to limit smoke movement as provided in Chapter 3, "Measures for Fire Safety in High Buildings" of the Supplement to the NBC, a switches at
liquids permitted to be located outside of a storage room or storage cabinet, in any one fire co~npartrnent of a building, shall not be more than a 600 L of flammable liquids
Concrete in Contact with Sulphate Soil 1 Concrete in contact with sulphate soil deleterious to normal cement shall conform to the requirements in Section 16 of CAN3-A23.1,
Delete the first 4 lines and substitute: 2 Where there is a common attic or roof space above more than 2 suites of residential occupancy or above more than 2 patients' bedrooms,
The First and Second Revisions dated January 1986 and January 1987, respectively, included updating of the referenced documents to 30 June 1986.. The revisions contained herein
