• Aucun résultat trouvé

EXPERIMENTAL STUDY OF DUCTILEFRACTURE IN WELDED JOINTS

N/A
N/A
Protected

Academic year: 2021

Partager "EXPERIMENTAL STUDY OF DUCTILEFRACTURE IN WELDED JOINTS"

Copied!
1
0
0

Texte intégral

(1)

Conférence Internationale sur le Soudage, le CND et l’Industrie des Métaux, IC-WNDT-MI’10 2010

EXPERIMENTAL STUDY OF DUCTILE FRACTURE IN WELDED JOINTS

Moussa ZAOUI, Noureddine MENASRI

Abstract : The pressure pipes of water reactors are made of A48 steel tubes and welded together. These welded joints are always preferred areas for the occurrence of defects and the requirement in terms of security for such facilities, thusmaking it essential to study their fracture. Comprehensive approaches such as the J integral of Rice, are used to analyze the harmfulness of defects in welds. This workhas explored the various parameters involved at the same time, to explain the phenomena of ductile tearing in a welded joint in order to develop an analytical method suitable for this type of junction. The tear tests showed the influence of volume fraction on the values of toughness and resistance to crack propagation J-?a. The fatigue tests showed that the fatigue strength of welded joints depends not only on the properties of base metal and filler metal used but also the presence of construction defects and internal defects. On the other hand, the study of the influence of welding conditions on toughness of welded joint steel Stainless steels, showed that the solder joint is obtained austenitic ferritic structure with a ferrite content appropriate This leads to the mechanical properties desired, move closer to the best ofthe middle of the band dispersion than the base metal. The numerical simulation of ductile tearing performed using the Rice-Tracey model based on the growth of voids, has highlighted the importance of parameters related to the model: in the case of a rate overmatching Importantly, the mechanical properties of the base metal has a pervasive effect on the overall behaviorof such structures and the growth rate of cavities R/R0 is sensitive to changes in the fields of stress and strainat the bottom of the crack

Keywords : Ductile fracture; A48 steel; Local approach

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

6 for the activation energy of the process suggests that hydrogen is indeed associated, and the observed relaxation is of the Snoek-type. This difference is due mainly to the

The increase in shear resistance of aluminum for both treatments and polyamide for plasma treatment follows the increase of total surface energy of both surface after treatment,

We have performed lattxce (interlayer spacing) relaxation calculations for three atomic layers of the two types of the incoherent twin boundaries, allow- ing the excess

On the other hand, the study of the influence of welding conditions on toughness of welded joint steel Stainless steels, showed that the solder joint is obtained austenitic

- The higher the welding energy, the larger the extent of HAZ; so, repairs have a small influence on the width of the HAZ, when the factors that affect the grain

In this current study, dissimilar metals weld between duplex stainless steel and low alloy steel, were produced employing tungsten inert gas process for the root pass

[r]

Lecture : 76 % des établissements ayant recruté sur un poste de cadre déclarent que le fait que le besoin était limité dans le temps est une raison importante ou très importante