• Aucun résultat trouvé

Machining Science and Technology

N/A
N/A
Info
Télécharger
Protected

Academic year: 2022

Partager "Machining Science and Technology"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

Machining Science and Technology

CONTENTS Volume 15, Number 3 2011

ENERGY DEPOSITION AND NON-THERMAL ABLATION

lN FEMTOSECOND LASER GROOVING OF SILICON 0 D. P. Wan,

Jun Wang, and Philip Mathew 263

INVESTIGATION OF THE TOOL WEAR AND SURFACE FINISH lN LOW-SPEED MILLING OF STAINLESS STEEL UNDER FLOOD AND MIST LUBRICATION 0 P. c.-Siow, Sebastian Dayou, and

W. y H. Liew 284

GRADE OF STABILITY lN FUZZY CHATTER STABILITY LOBE

MODEL lN MILLING 0 Ming Chen, Weiwei Ming, and Xiaohui Zhang 306 MACHINING CHARACTERISTICS OF COMPLEX SURFACES

USING FAST TOOL SERVO SYSTEM 0 Gui Lin Wang, Yi Fan Dai,

Zi Wen Zheng, and Deng Chao Zhu 324

INFLUENCE OF CLAMPING STRATEGIES ON ROUNDNESS

DEVIATIONSOF TURNEDRINGS0 Jens S6lter, Christian Grote, and

Ekkard Brinksmeier 338

Il 111111111 III

10910344(2011)15(3)

C\ Taylor& Francis

~

Taylor & FrancisGroup

Références

Télécharger maintenant ( PDF - 1 Page - 354.87 KB )

Documents relatifs

HISTORY OF THE HARDENING OF STEEL : SCIENCE AND TECHNOLOGY

About 1900 Osmond believed beta-iron was the cause of the hardening since the normal transformation to alfa- iron was prevented by the sudden cooling.. In 1895 both theories

Experimental Investigation of Friction Coefficient and Wear Rate of Brass and Bronze under Lubrication Conditions

The analysis of the microstructure of brass shows a high shear of the surface layers, with a severe plastic deformation, which is not the case for the bronze that is

A numerical investigation on oil mist behavior used in Minimum Quantity Lubrication milling process

Focusing on contours of pressure on the milling tool teeth, simulations showed that, by increasing the rotating velocity, total relative pressure increases especially in the bottom

NSP1B3 : un logiciel pour resoudre les equations de Navier Stokes incompressible 3D

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

~Machining Science and Technology

INFLUENCE OF MACHINING PARAMETERS ON THE WHITE LAVER FORMATION PROCESS AND ITS CHARACTERISTICS lN TURNING OF HARDENEDSTEEL 0

Machining Science and Technology

PLANARIZA TION 0 Ruqin Zhang, Xiaoping Wang, Pranav Shrotriya, Rana Biswas, Ashraf Bastawros, and Abhijit

Machining Science and Technology

SURFACE ROUGHNESS PARAMETERS OPTIMIZATION lN MACHINING A356/SiC/20p METAL MATRIX COMPOSITES BY PCD TOOL USING RESPONSE SURFACE METHODOLOGY AND DESIRABILITY FUNCTION

Machining Science and Technology

POLISHING MACHINE TOOL 0 Guilian Wang and YIqiang Wang WEAR STUDIES AND CUTTING TESTS OF Ti-AI-N-C. NANOCOMPOSITE COATINGS lN MILLING