• Aucun résultat trouvé

Reduced order modeling for physically-based augmented reality

N/A
N/A
Protected

Academic year: 2021

Partager "Reduced order modeling for physically-based augmented reality"

Copied!
19
0
0

Texte intégral

Loading

Figure

Fig. 1. The virtuality continuum.
Fig. 2. Sketch of the Structure from Motion problem.
Fig. 3. Cantilever beam problem. A moving load P is parameterized through its position coordinate s.
Fig. 6. Modes G i (s), i = 1 , . . . , 5, for the aluminum beam problem.
+7

Références

Documents relatifs

Pour les filles, les éléments les plus remarquables de la puberté sont le développement mammaire, le développement de la pilosité génitale et axillaire, un pic

Cet article illustre le lien entre identification partielle dans les modèles écono- métriques et critère de décision de Jaffray dans l’incertain non probabilisé à travers

Pour cela, il convient d’évaluer d’une part, le portefeuille de dettes courant avec le nouvel encours sous la structure qui prévalait avant passage des opérations, càd en

Apostolos, "Cathodic Protection of Reinforced Concrete by Using Metallized Coatings and Conductive Paints," Transportation Research Record 962, TRB (Washington,

The output parameters being studied were drawbar force (required to be applied on the wheel to maintain input translation velocity), torque (required to be applied

Our analysis is based on the symplectic reduction of the quadratic form defining the Hamiltonian (inspired by the computations of Fetter [8]), the characterization of a lowest

Freund, Reduced-order modeling of large linear subcircuits via a block Lanczos algorithm, in: Proceedings of the 32nd ACM=IEEE Design Automation Conference, ACM, New York, 1995,

to the FOM and the serial approach is expected.. TEST CASE - BACKWARD FACING STEP.. TEST CASE - BACKWARD FACING STEP.. TEST CASE - BACKWARD FACING STEP.. the same number of basis),