• Aucun résultat trouvé

Mechanical analysis of local cutting forces and transient state when drilling of heat-resistant austenitic stainless steel

N/A
N/A
Protected

Academic year: 2021

Partager "Mechanical analysis of local cutting forces and transient state when drilling of heat-resistant austenitic stainless steel"

Copied!
13
0
0

Texte intégral

Loading

Figure

Fig. 1 Decomposition of chisel edge and cutting edge into elementary cutting edges cutting conditions: drill_Z3, V c = 30 m/min, f z = 0.035 mm/
Fig. 3 Rake angle γ n variation along the cutting edge of the drill_Z2 and drill_Z3
Table 2 Effect of the feed and cutting speed on the peak appearance on cutting forces (P: peak, NP: no peak, NT: not tested)
Figure 7b shows an example of initial chip obtained during the drill tip penetration of the drill_Z3
+7

Références

Documents relatifs

The aim of the present study is to investigate the effects of solvent type (ethanol, methanol, acetone and water), acetone concentration (20–100%, v/v), solvent acidity

Dans son Exposition du système du monde (1796), Laplace formule une hypothèse cosmogonique pour rendre compte de ce que les mouvements des planètes et de leurs satellies se font

On the diagnosis part, we con- centrate on the sensors fault diagnosis (truck velocity sensor, wheels angular velocity sensors, radar, engine sensors).. We suppose during this

جئاتـــنلاو بييرجتلا لمعلا.. جئاتنلاو يبيرجتلا لمعلا ث لاثلا لص فلا 51 لمعلا يف عبتملا يرارحلا للاحنلإاب شرلا ماظن لوح راكفلأا نم ةعومجم ميدقت ىلإ لصفلا

We used our test to compare net survival distributions between Black and White patients stratified on stage, which is known to have an important effect on net cancer survival..

Cette idée est justifiée par l’analyse d’un extrait d’une transcription (ci-dessous). Dans ce cours extrait, il est en effet possible de constater que les élèves sont

désire atteindre l’union. Cette union n’est possible que par l’entremise de la migentheit222, cette entité réceptive à Dieu qui a la possibilité de devenir toutes choses.

Pour présenter le point de vue de l’Église catholique 1 , la présente contribution partira du droit canonique et de la doctrine du magistère suprême, afin d’esquisser des