• Aucun résultat trouvé

A space–time approach in digital image correlation: Movie-DIC

N/A
N/A
Protected

Academic year: 2021

Partager "A space–time approach in digital image correlation: Movie-DIC"

Copied!
13
0
0

Texte intégral

(1)

Science Arts & Métiers (SAM)

is an open access repository that collects the work of Arts et Métiers Institute of Technology researchers and makes it freely available over the web where possible.

This is an author-deposited version published in: https://sam.ensam.eu

Handle ID: .http://hdl.handle.net/10985/7334

To cite this version :

Gilles BESNARD, Sandra GUERARD, Stéphane ROUX, François HILD - A space–time approach in digital image correlation: MovieDIC Optics and Lasers in Engineering Vol. 49, n°1, p.7181 -2011

Any correspondence concerning this service should be sent to the repository Administrator : archiveouverte@ensam.eu

(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)

Références

Documents relatifs

La tonalité triomphaliste et parfois revancharde des écrits qui nous annoncent leur « échec » ou leur « dépassement » montre par ailleurs que l’émergence d’une modernité qui

Three control experiments were performed: (i) a control containing ZVINs in water with no TNG to determine ZVINs stability in water, (ii) a control containing nanostructured

(d) A mechano-chemical coupling between the two subsystems is achieved by increasing the strength of the flows generated by the active gel, which induces four different

De plus, les participants à l’étude devaient être considérés comme de mauvais candidats pour un traitement avec un analogue de purine, soit parce qu’ils avaient eu une période

Displacement jumps of the order of 1.5 voxel (1 voxel = 13.5 µm) are obtained at one of the corners of the crack, while the sample face average crack opening (i.e., discontinuity of

Tensile tests confirm composites reinforcement at a low level of nanocomposites incorporation and local analysis enables quantitative measurements of adding maleic anhydride in

Figure 3 shows the change of the standard error between the measured and prescribed displacement eld for the dierent regularization lengths ℓ m.. when ℓ b /ℓ m is set to

Safety assurance through advances in long-term operation requires research and development activities that tackle, extended period materials performance, selection of materials for