QUALITY CONTROL VIA ELECTRICAL RESISTIVITY MEASUREMENT OF INDUSTRIAL ANODES
Yasar Kocaefe, Duygu Kocaefe, Dipankar Bhattacharyay
1
Texte intégral
1
Figure
Documents relatifs
La principale difficulté est alors que, si l’étude des mobiles se prête bien à l’étude des distances à un point marqué dans une carte aléatoire, elle semble à première vue
The cross-CoI collaboration on the re-design of the “Limits” c-book was organized in the following five phases: (1) a part of the French CoI, acting as the primary designers,
On the other hand, one of the most fascinating properties of spin glasses, which makes this state of matter a very peculiar one, is the onset of remanence effects for very weak
After preparation the samples were kept at 140 K or lower and stored, handled and mounted for experimental measurements under liquid nitrogen The hydrogen content x was
ted of the temperature dependent part of the resistivity p(T) of aluminum, for the first time of a precision sufficient to determine the tempe- rature dependence in the
L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des
Abstract.- The electron scattering on dislocations is calculated taking into account the influence of dislocations on the phonon spectrum of a metal (line a perturbation of
solution of the phonon Boltzmann equation for the case of mixed phonon-electron and phonon-dislo- cation scattering.. A wide range of reasonable dislocation densities