• Aucun résultat trouvé

Sensitivity of thermal infrared directional anisotropy to canopy and meteorological conditions

N/A
N/A
Protected

Academic year: 2021

Partager "Sensitivity of thermal infrared directional anisotropy to canopy and meteorological conditions"

Copied!
4
0
0

Texte intégral

(1)

HAL Id: hal-02795233

https://hal.inrae.fr/hal-02795233

Submitted on 5 Jun 2020

HAL is a multi-disciplinary open access archive for the deposit and dissemination of sci- entific research documents, whether they are pub- lished or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers.

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d’enseignement et de recherche français ou étrangers, des laboratoires publics ou privés.

Sensitivity of thermal infrared directional anisotropy to canopy and meteorological conditions

Clément Duffour, Albert Olioso, Jérôme Demarty, Jean-Louis Roujean, Jean-Pierre Lagouarde

To cite this version:

Clément Duffour, Albert Olioso, Jérôme Demarty, Jean-Louis Roujean, Jean-Pierre Lagouarde. Sensi- tivity of thermal infrared directional anisotropy to canopy and meteorological conditions. RAQRS’IV, 4th International Symposium on Recent Advances in Quantitative Remote Sensing, Sep 2014, Valen- cia, Spain. 2014. �hal-02795233�

(2)

4th INTERNATIONAL SYMPOSIUM: RECENT ADVANCES IN QUANTITATIVE REMOTE SENSING

83

SENSITIVITY OF THERMAL INFRARED DIRECTIONAL ANISOTROPY TO CANOPY AND METEOROLOGICAL CONDITIONS

Duffour C.1,2, Olioso A.3, Demarty J.4, Roujean J.-L.5, Lagouarde J.-P.1,2

1 INRA, UMR 1391 ISPA, F-33140 Villenave d’Ornon, France;

[email protected] ; Tel. +33 5 57 12 24 27

2 Bordeaux Sciences Agro, UMR 1391 ISPA, F-33170 Gradignan, France ;

3 INRA, UMR1114, EMMAH, F-84914, Avignon, France ;

4 IRD, UMR HydroSciences Montpellier, Université Montpellier 2, Montpellier, France ;

5 Météo France CNRM-GAME, F-31057, Toulouse, France

Land Surface Temperature measurements are prone to important directional anisotropy and hot spot effects. These are governed by the coupled energy and radiative transfer within canopies, and therefore depend on the viewing angles, on the Sun position (i.e. time and season), on the canopy (structure and water status), and on micrometeorological conditions. The future missions combining both high spatial resolution and revisit capacities in the thermal infrared (TIR) such as THIRSTY (Crebassol, et al. 2014) require the directional anisotropy (defined as the difference between oblique and nadir temperatures) to be correctly assessed. That’s why we must develop correction algorithms simple and robust enough to be compatible with the processing of data from space and the elaboration of final products. The development, calibration and validation of these algorithms require large amounts of data. For this purpose we use the SCOPE (Soil Canopy Observation, Photochemistry and Energy fluxes, Van der Tol et al. 2009) model. It is a soil vegetation atmosphere transfer (SVAT) multilayer model coupling radiative transfer (4SAIL) and energy balance able to simulate energy fluxes and directional brightness temperatures.

We first briefly describe the model and its validation against experimental data over wheat and forest canopies, and illustrate its ability to simulate the directional anisotropy of brightness surface temperatures in a large range of zenithal and azimuthal viewing directions.

The model is then used to evaluate the sensitivity of anisotropy to different canopy structure and meteorological variables. Among the parameters tested, the wind speed, the LAI and the stomatal conductance reveal to have major impact as expected because they directly govern the sensible and latent heat fluxes and therefore surface temperature. Results show that the anisotropy significantly decreases with wind speed, LAI increase and especially when water needs are satisfied (i.e. increase of stomatal conductance).

These will have to be introduced in TIR data processing algorithms for either correcting temperatures from directional anisotropy effects or normalizing them into a given reference viewing geometry. Their determination from complementary data obtained from meteorological networks or from remote sensing (such as vegetation indices or water stress indices) is discussed and guidelines provided.

(3)
(4)

4 th INTERNATIONAL SYMPOSIUM

RECENT ADVANCES IN QUANTITATIVE REMOTE SENSING

PROGRAMME AND ABSTRACT BOOK

22 – 26 SEPTEMBER 2014

TORRENT (VALENCIA) SPAIN

Références

Documents relatifs

Let us now recall our main results of section VIII on radiative heat transfer :.. • In the plane-plane case, the heat flux associated with the profiles of SiO 2 has a convex

Measured (solid line) and modeled (dashed line) reflectance spectra, excluding data in the main atmospheric absorption bands of one soil at various levels of soil water content:

For the simulation of these clouds, we will developed an algorithm for the identification of cloud types and cloud structure, based on the vertical profile of the cloud liquid

yellow colour indicates thermal and/or solar radiation that is scattered. DART and MODTRAN-5 configurations are detailed in section 3. Profiles of DART initial and improved

This study aims to perform a sensitivity study with respect to the uncer- tain model inputs of two classical approaches used to map the evapotranspiration of agroecosystems: (1)

The measurements of TIR directional anisotropy performed during nighttime about 5 hours after sunset over the old city centre of Toulouse in February 2005 revealed limited

It is clear that the two methods, that is to say, the vibrational conductivity method on the one hand and the radiative energy transfer method on the other hand, apply for

Modelling SMOS brightness temperature by use of coupled SVAT and radiative transfer models over the Valencia Anchor Station.. EGU General Assembly, Apr 2009,