• Aucun résultat trouvé

What is the weather like today ?

N/A
N/A
Info
Télécharger
Protected

Academic year: 2022

Partager "What is the weather like today ?"

Copied!
2
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

What is the weather like today ?

http://laclassedeguena.eklablog.com

(2)

It’s sunny It’s foggy It’s rainy It’s cloudy

It’s snowy It’s stormy

It’s cold It’s warm It’s hot

The sea is calm The sea is rough

It’s sunny It’s foggy It’s rainy It’s cloudy

It’s snowy It’s stormy

It’s cold It’s warm It’s hot

The sea is calm The sea is rough It’s partly cloudy

with sunny intervals.

There’s a light wind

There’s is a moderate wind.

There’s a strong wind

It’s partly cloudy with sunny

intervals.

There’s a light wind

There’s is a moderate wind.

There’s a strong wind

Références

Télécharger maintenant ( PDF - 2 Page - 146.57 KB )

Documents relatifs

first It it It difficult, it. It It it's it

All non-printing characters may used to will be disríLayed as periods t.: command is which "P" disolay the results of the allows kevboard entry of ASCII characters directly

it it

unit configuration. This is described in Chapter IV. Initialize the directories on the target disk and verify that files can.be writtentQ and read back from the

,é'),, If It it it it

IN GLOBAL RE' ER£NCE ILLEGAL NOT ON GLOBAL ?ILE DISK ROUTINE NOT ON DISK DISK I/O ERROR ROUTINE IS UNNAMED ROUTL1E ALREAD'Í j;q LIBRARY REMOVE OR SAVE ROUTINÍ COMMAND ONLY USED

it It

SYSTEM CONFIGURation Version Vx.x TeleVideo Systems, Inc. To change floppy disk format. 8) To EXECUTE AND SAVE current configuration and

it it

The format test program formats the hard disk and then performs the write test. The format test should only be executed if

it it

To convert an n-column decimal number into its binary form it is possible to store the binary equl valents of the n powers of ten and perform the requl si te

it it

The expansion memory will be easily' installable with only a screwdriver (for removal of back panel only) and will require no setting of switches or attachment

it it

The errors have been reorganized and new ones are added. b) Th~ assembler does not recognize- the-- directive .ABSOLUTE anymore.. The .CODE file generated by this