• Aucun résultat trouvé

CONTRIBUTION TO RECONFIGURATIONOF FAULT-TOLERANT INVERTER APPLIEDTO THE WIND PARK CONNECTED TO THEELECTRICAL NETWORK

N/A
N/A
Protected

Academic year: 2021

Partager "CONTRIBUTION TO RECONFIGURATIONOF FAULT-TOLERANT INVERTER APPLIEDTO THE WIND PARK CONNECTED TO THEELECTRICAL NETWORK"

Copied!
1
0
0

Texte intégral

(1)

Revue Roumaine des Sciences Techniques

Volume 64, Issue 2, 2019, Pages 143-148

CONTRIBUTION TO RECONFIGURATION OF FAULT-TOLERANT INVERTER APPLIED

TO THE WIND PARK CONNECTED TO THE ELECTRICAL NETWORK

Omar Fethi BENAOUDA, Azzedine Bendiabdellah, KAHLA SAMI

Abstract: This paper proposes a new diagnostic technique based on Park vectors associated with polar coordinates for the detection and location of open circuit (OC) faults, as well as the integration of fault-tolerant reconfigurable inverter in order to enable continuity of service of the wind farm system. The model used is that of a variable speed wind turbine coupled to a double-fed induction generator (DFIG) connected to the power grid via a fault-tolerant converter to improve performance after the appearance of the fault. This converter is used based on IGBT to obtain an acceptable accuracy with high switching frequencies. This model is well suited for the observation of harmonics and the dynamic performance of the control system over relatively short periods of time (typically hundreds of milliseconds to one second). This method allows extracting the maximum wind energy during a low wind speed by optimizing the turbine speed while minimizing the mechanical stress on the turbine during gusts of wind. To illustrate the diagnostic improvement of fault-tolerant inverter open circuit faults, several results are presented and discussed in this article.

Keywords : DFIG Turbine, Inverter, diagnosis, Detection, Location, Reconfiguration, fault, Open-Circuit, IGBT

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

In this paper, a new approach is proposed to design a sensor fault tolerant controller for nonlinear complex sys- tems represented by Takagi-Sugeno model.. The approach is based on

ABSTRACT: The paper presents an advanced wind forecasting system that uses on-line S CADA measurements, as well as numerical weather predictions as input to predict the

The article is structured as follows: section 2 highlights some aspects on Bayesian networks and particularly on Bayesian network classifiers; section 3 presents the various T

Starting from the patterns mentioned above, we can calculate the geometrical characteristics of the Hilbert modulus-Park Lissajou’s curve and the Hilbert

energy, by a photovoltaic generator system. These cells are placed in series for objective to increasing the generator voltage, and in parallel to increasing the

power of a PV generator decreases proportional to the number of the defective diodes. Because, this fault can affects the group voltage. But, the current remains independent

Once the transformer is connected to the bus bar, it will feed several lines where the loads are connected. The figure 2.4 represents a solidly grounded distribution network with

Based on Lyapunov theory, two new approaches are proposed in term of Linear Matrix Inequalities (LMI) leading to synthesize an FTC laws ensuring the tracking between the reference