• Aucun résultat trouvé

Contact resistance in flat thin films

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Contact resistance in flat thin films"

Copied!
8
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

Loading

Figure

Figure 1. a) The current flow lines between two bulk marterials meeting at a contact spot as assumed in traditional contact theory
Figure 2. The contact spot radius a, the film outer radius b, and the film thickness L, for thin films meeting at a single asperity
Figure 6. Apparent area of contact, actual area of contact, inidividual contact spots, and the diameter of the stiff center cylinder of the experimental setup
Figure 9. a) Current flow lines in traditional film theory. b) Current flow lines in a thin electroplated film on a sputtered seed layer
+2

Références

Télécharger maintenant ( PDF - 8 Page - 385.66 KB )

Documents relatifs

Clustering and the spatial distribution of contact spots at a real un-dismantled electrical contact interface

Increasing the contact force from 0.8 kN to 1.6 kN results in an increase in the spot size fractal dimension, D, which indicates that the spot number is increasing at a faster rate

Numerical study of the gasket thermal conductivity effect on the thermal contact resistance between two solids in contact

(1999) developed an experimental study to simulate the real contact conditions during glass solidification and built a numerical procedure to estimate the thermal parameters (left

Intuitive and broadly applicable definitions of niche and fitness differences

Experiments and field data have shown that pigmentation differences among picocyanobacteria lead to a resource (light) partitioning that is sufficiently strong to allow

The contact of The contact of

The value of the contact angle   c c is important for the existence of is important for the existence of liquid channels where grain boundaries meet walls. Indeed, these

RF MEMS electrical contact resistance calculation using mechanical contact simulations and analytical models

This numerical method is used to predict the real contact area as a function of the contact force between rough surfaces starting from real shape of the surfaces that come in

Contact:

A cet effet, l’Initiative pour la Transparence dans les Industries Extractives (ITIE) est une initiative volontaire qui vise à renforcer, dans les pays riches en

Sur le contact des surfaces

Si donc on suppose que 83 soit donné, divisible par Sg, les équations (8) et les deux premières des équations (9) déterminent, dans l'hypothèse m =2, un faisceau de surfaces du

Sur le contact des courbes et des surfaces

» Dans le cas particuhei ou la surface donnée est du troisième degré, les positions singulières du plan sécant mené par une tangente quelconque pour lesquelles le contact avec