• Aucun résultat trouvé

MPPT Control of a Small PV Generation Systemunder Diverse Weather Conditions

N/A
N/A
Protected

Academic year: 2021

Partager "MPPT Control of a Small PV Generation Systemunder Diverse Weather Conditions"

Copied!
1
0
0

Texte intégral

(1)

Conférence Internationale des Energies Renouvelables "CIER’13" / International Journal of Scientific Research & Engineering Technology

Volume 01, Issue 02, 2014, Pages 0-0

MPPT Control of a Small PV Generation System under Diverse Weather Conditions

Fouzia BRIHMAT, Said MEKHTOUB

Abstract: The power induced in the photovoltaic modules is influenced by the intensity of solar cell irradiation, temperature of solar cells and moreover by the load. Therefore, to maximize the efficiency of the renewable energy system, it is necessary to track the maximum power point of the input source. In this work, we tie to present the constituent of a weak power PV chain dedicated to the storage on battery. The battery bank is connected to the DC network via a DC/DC boost converter, called the storage converter, used for controlling the network.Indeed, the battery is only imperative buffer storage in this case. The PV units are connected to the DC network via its own DC/DC converter, called PV converter, to ensure the required power flow. The purpose of the proposed model is the simulation of the complete system behavior from the electric and energy point of view. A maximum power point tracker (MPPT) scheme is applied through the boost converter to improve the energy conversion efficiency. Fuzzy algorithm based on linguistic rules describing the operator’s control strategy is applied to control the step-up converter for MPPT. On the other hand, Fuzzy logic control based on coarse and fine mode is incorporated in order to reduce not only the time required to track the maximum power point but also power fluctuation. A confrontation with a P and O method performed. Another fuzzy battery-charge controller is also applied. Simulation results show that the proposed fuzzy controller exhibits a better performance than the controller based upon the P and O method.

Keywords : Photovoltaic, simulation, MPPT; DC-DC converter, Fuzzy controller

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

In these systems, instead of Pulse Width Modulation (PWM), PFM is employed, where a constant ON time is used for the control of the converter power switch, while

By combining the PV module and converter model with the fuzzy logic controller, we created the complete Maximum Power Point Tracker (MPPT) model, using it to tune the fuzzy

Hybrid model and proposed control law In this section we design an hybrid dynamical system, following the paradigm given in [13], wherein continuous- time behavior encompasses

In this paper, hybrid HCS algorithm (HHCS) is presented to track the maximum power point, MPP, where the OTC method is merged with HCS to solve the two

From equation (1) we notice that the output current of the PV module depends on the photocurrent itself, which itself depends on the solar insolation and the junction temperature of

TRACKING THE POINT OF MAXIMUM POWER (MPPT) In order to overcome the above mentioned undesired effects on the PV output power, a maximum power point tracker (MPPT)

According to the rotor speeds, we use (or not) gearbox to increase speeds required by electrical generator. The turbine control includes two major parts: i) power

Abstract - This paper proposes a novel single sensor maximum power point tracking method for PV system composed of Solarex MSX-60W PV panel operating at