• Aucun résultat trouvé

Effects of Niobium and Molybdenum onMicrostructures after Hardeningand WearResistance of Austenitic Manganese Steel

N/A
N/A
Protected

Academic year: 2021

Partager "Effects of Niobium and Molybdenum onMicrostructures after Hardeningand WearResistance of Austenitic Manganese Steel"

Copied!
1
0
0

Texte intégral

(1)

Chemistry and Materials Research

Volume Vol 5 (2013), 2013, Pages 0-0

Effects of Niobium and Molybdenum on Microstructures after Hardeningand Wear

Resistance of Austenitic Manganese Steel

ali hadji, BOUHAMLA Khedidja

Abstract: Hadfield steel has been wildly used to manufacture railway crossings because of its excellent workhardening, high strength and toughness properties. The hardness of Hadfield steel is only about 20 HRC whensubjected to water toughening. This low hardness is usually associated with poor wear resistance and severeplastic deformation, as well as abrasion of the working surface of the railway crossing during the initial serviceperiod, which remarkably reduces its service lifetime. In this study we focus on the influence of niobium andmolybdenum on the phenomenon of surface hardening or work hardening and wear resistance.

Thetransformation of austenite during operation, thus determines the steel operating lifetime, the rate oftransformation of austenite to martensite can introduce a compromise between ductility and wear resistance ofthe steel to support large efforts without breaking.

The objective of this study is to improve the wear resistanceby abrasion and friction after heat treatment of manganese steel alloyed with niobium and molybdenum. Theaddition of niobium and molybdenum promotes secondary hardening and allows slower transformation ofaustenite during the heat treatment. The results showed that the introduction of niobium and molybdenum hasstrongly influenced the character of the structure crystallization before hardening (Part hardened) byprecipitation carbides form and finesse variables is observed in the microstructure before heat treatment andcomplete dissolution is noted after heat treatment, for the hardened part (work hardening) we observed agreater thickness and hardness compared to the base steel and net improvement in wear resistance.

Keywords : manganese steel, Effects of Niobium and Molybdenum, Hardeningand, Hardeningand Wear Resistance

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

About 1900 Osmond believed beta-iron was the cause of the hardening since the normal transformation to alfa- iron was prevented by the sudden cooling.. In 1895 both theories

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The results showed that the introduction of niobium and molybdenum has strongly influenced the character of the structure crystallization before hardening (Part hardened)

Wear investigations were carried out on the as cast and heat treated state of a slightly hypoeutectic high chromium cast iron.Results showed that the studied alloy is composed of

Previous study indicates that wear resistance of high chromium cast iron is related to the microstructural parameters of the eutectic carbides, such as volume

According to the microstructure formed after quenching, thetransformation of austenite into martensite during working, determine the operating life.The rate of transformation

The results showed that the introduction of niobium and molybdenum has strongly influenced the character of the structure crystallization before hardening (Part hardened)

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des