• Aucun résultat trouvé

Studies of Iron Diselenide Thin Films Depositedby Thermal Evaporation

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Studies of Iron Diselenide Thin Films Depositedby Thermal Evaporation"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

7th African Conference on Non Destructive Testing ACNDT 2016 & the 5th International Conference on NDT and Materials Industry and Alloys (IC-WNDT-MI)

2016

Studies of Iron Diselenide Thin Films Deposited by Thermal Evaporation

A. Kassaa, N. Benslim

Abstract : Iron diselenide (FeSe) composite thin films have been formed onto ultrasonically and chemical cleaned glass substrates by thermal evaporation technique from powder. This latter was prepared by mechanical alloying. The structural evolution of a binary alloy with nominal composition FeSe2 prepared by ball milling was investigated as a function of milling time. The structural properties of the powders and the films were ascertained by x-ray diffraction method. The XRD patterns showed that for milling times up to 1 h, the FeSe phase is formed. The band gap E estimated from optical absorption data was between 0.8–1.01 eV, depending on preparation conditions such as substrate temperature. High optical absorption coefficients (> 104 cm? 1g) were found.

Keywords : FeSe, Solar energy materials, Mechanical Alloying, Thermal evaporation, Thin films

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Télécharger maintenant ( PDF - 1 Page - 7.80 KB )

Documents relatifs

Modèles et outils pour définir le soutien dans les environnements hypermédias d'apprentissage

Le soutien dans les environnements d’apprentissage est fondé sur l’utilisation d’un modèle de la tâche, d’un modèle de l’apprenant qui doit être déduit durant l’activité

Microstructural Study of Thin Films CuFeObtained by Thermal Evaporation ofNanostructured Milled Powder

The elaboration of our films has been carried out using thermal evaporation process (physical vapor deposition) under 1 × 10-6 mbar vacuum from an electrically heated tungsten

Paper Title: Microstructural Study of Thin Films CuFe Obtained by Thermal Evaporation of Nanostructured Milled Powder

The elaboration of our films has been carried out using thermal evaporation process (physical vapor deposition) under 1 × 10 -6 mbar vacuum from an electrically heated tungsten boat,

Studies of Iron Diselenide Thin Films Deposited by Thermal Evaporation

In this paper, we report on preparation of the nanocrystalline FeSe 2 powder by mechanical alloying (MA) process and investigation of structural and optical

MOKE Magnetometer Studies of Evaporated Ni and Ni/Cu Thin Films onto Different Substrates

Therefore, in our study, we believe that the main origins of the coercive field behavior are the magnetic anisotropy, the grain size effect and the surface morphology which depend

PHYSICAL PROPERTIES OF THIN FILMS OF IRON OXIDES

y - Fez03 has the same spinel structure as FesO4 and is obtained by further oxidation (annealing in air) of this compound. cvFezO3 is the most stable oxide and was

Contribution à l’étude des composés FeSe2

Iron diselenide (FeSe2) composite thin films have been deposited at vaccum on glass substrates by thermal evaporation technique from powder.. The depositon of FeSe2 thin films on

The Benefits of Re-Evaluating Real-Time Fulfillment Decisions

We conjecture that we can reduce the total transportation cost of shipping orders from warehouses by re-evaluating the real-time assignment decisions, subject to the constraint