• Aucun résultat trouvé

and an analytical verification Piezoelectric transformer: Comparison between a model

N/A
N/A
Protected

Academic year: 2021

Partager "and an analytical verification Piezoelectric transformer: Comparison between a model"

Copied!
1
0
0

Texte intégral

(1)

Computers and structures 86 (2008) 374–378

Piezoelectric transformer: Comparison between a model and an analytical verification

F. Boukazouha, F. Boubenider

Centre de Recherche Scientifique et Technique en Soudage et Contrôle, B.P. 64, Route de Delly Brahim, Che´raga, Alger, Algeria

Abstract:

In this paper, a study comparing a model of a composite piezoelectric transformer, based on the corresponding electrical equivalent circuit, and the direct calculation solving the mechanical fundamental equations constrained by the appropriate boundary conditions is presented. The approach is simplified considering vibrations only along one direction, neglecting the coupling phenomena existing along the other directions. The electrical equivalent circuit of the transformer is obtained from the equivalent circuit referred for the isolated piezoelectric oscillators. In this paper, each electrical equivalent circuit is placed on a cascade in order to conserve the continuity of dis- placements and stress at the junction.

Keywords: Piezoelectricity; Transformer; Modeling; Equivalent circuit; Analytical verification; Voltage gain; Boundary conditions

Références

Documents relatifs

The subtotal cost to realise the ultrafiltration unit for the treatment of the surface water from Keddara Dam, presented in Table 6, is obtained by addition of the cost of the

Abstract: In this paper, a study comparing a model of a composite piezoelectric transformer, based on the corresponding electrical equivalent circuit, and the direct calculation

In the current study, a micromechanical model based on transformation field analysis been used to quantify the overall material properties of electrically active

The CIB W080 WC continues support of PeBBu network Domain 1 activities in that the WC’s work programme has focused to further develop the Factor Method and the Reference Service

We model the bibliographic data as a 3-mode network, in which the nodes represent the concerned conference, the articles related to the conference editions (i.e., the articles

Therefore, VOC control is the key to achieve lower 03 levels when total NOx emissions are 0.4 times our base case NOx emissions or higher.. Control of NOx emissions in order

By contrast, the operating conditions corre- sponding to the regime where the pore filling by liquid water results from both condensation and liquid injection leads to higher

Individual trajectories of disease progression are constructed from the average trajectory by using subject-specific space shifts, acceleration factors and time shifts, which allow