Design and deformation behavior of highstrength Fe–Mn–Al–Cr–C duplex steel

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Abstract : The aim of this work is to study the recrystallization in the 904L austenitic stainless steel, which underwent a cold rolling with two different deformation amounts (50

The microstructure of the as received 904L alloy is shown in Figure 1-a. The microstructure consists of a matrix γ phase, with equiaxed grains randomly distributed, without

In addition, depending on the steel compositions and process parameters, the plasma mass transfer has an effect on the formation and thickness of compound layer and diffusion

In order to investigate aging and restoration behavior of this steel and the influences on mechanical properties, aging treatments at 850°C (after annealing at 1080°C and 1120°C)

Abstract: Duplex stainless steels 2205 are widely used in constructional and petrochemical applications because of their good mechanical and corrosion properties. The objective of

Abstract : Duplex stainless steels (DSS) are prone to intermetallic phase formation at high temperatures, which can drastically decrease the toughness property.. This work

After aging treatments, all samples were annealed at 1080°C for 60 min and quenched in water; this treatment led to a complete dissolution of sigma phase and