Electron heating in metallic resistors at sub-Kelvin temperature
Texte intégral
Figure
Documents relatifs
L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des
To prove Theorem 2.1 we shall consider Galerkin’s approximations of equation (2.10) and construct an approximate solution of this equation. and a neighborhood of this
Typically, for the methane molecule, at 2500 K the maximum contribution is around 10 000 cm − 1. Unfortunately, this spectral region is far from being exhaustively modelled at
L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des
In this work, low frequency noise measurements versus temperature are used as a device characterization tool in order to evaluate the quality of the gate oxide
The observer proposed in Theorem 2, with a constant gain (27), is now applied on two real data sets (a normal use and a battery overcharge) for the reconstruction of the cell
After the determination of electromechanical coupling factor k 2 , quality factor Q, and the temperature coefficient of frequency TCF of the structure, we studied, by
Effects of the temperature and the incident electron current density on the total electron emission yield (TEEY) of polycrystalline diamond deposited by chemical vapor
