• Aucun résultat trouvé

LNE Activies in Nanometrology: flatness reference calibration algorithm

N/A
N/A
Protected

Academic year: 2021

Partager "LNE Activies in Nanometrology: flatness reference calibration algorithm"

Copied!
6
0
0

Texte intégral

Loading

Figure

Figure 2: straightness measurement using 4 capacitive sensors (left), convention used  to locate the relative position of the sensor (a) the points of the profile (b)
Figure 3: developed bench
Figure 4: deviation to the mean value of straightness profiles obtained using the  weighted least squares

Références

Documents relatifs

This method proposes to complement low-cost inertial sensors commonly used in navigation techniques (accelerometers and gyroscopes [5], [2]) with a specific device consisting of

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

the previously selected pairs, the points (p3-m2) corresponding to the minimum distance (d2) of the resulting matrix are then chosen as another match, and so on. As illustrated

For a continuous liquid level detection, the electrodes forming the planar condenser are evaporated on a flexible plastic film in an interleaved geometry shown in

Ecrire ce que représente chacune des figures suivantes en utilisant les mots : qui passe, origine et extrémités.. Tracer (AB). Tracer [CB). [MB)

This is attributed to the fact that an in fi nite number of planes, bearing on the bump (or bumps) of its axisymmetric surfaces, lead to the same minimum sum of deviations and that

13 Sezione INFN di Bari, Bari, Italy 14 Sezione INFN di Bologna, Bologna, Italy 15 Sezione INFN di Cagliari, Cagliari, Italy 16 Sezione INFN di Ferrara, Ferrara, Italy 17 Sezione

Thus each mathematical symbol (G, L,. .) has a single definite meaning inside each exercise, but might have different meanings from an exercise to another.. It is not required to