• Aucun résultat trouvé

Toughened carbon nanotube-iron-mullite composites prepared by spark plasma sintering

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Toughened carbon nanotube-iron-mullite composites prepared by spark plasma sintering"

Copied!
8
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

To cite this version : Weibel, Alicia and Peigney, Alain and Chevallier, Geoffroy and Estournès, Claude and Laurent, Christophe. Toughened carbon nanotube-iron-mullite composites prepared by spark plasma sintering. (2013) Ceramics International, vol. 39 (n° 5). pp. 5513-5519. ISSN 0272-8842

O

pen

A

rchive

T

OULOUSE

A

rchive

O

uverte (

OATAO

)

OATAO is an open access repository that collects the work of Toulouse researchers and makes it freely available over the web where possible.

This is an author-deposited version published in : http://oatao.univ-toulouse.fr/

Eprints ID : 9359

To link to this article : DOI:10.1016/j.ceramint.2012.12.063 URL : http://dx.doi.org/10.1016/j.ceramint.2012.12.063

Any correspondance concerning this service should be sent to the repository administrator: [email protected]

(2)
(3)
(4)
(5)
(6)
(7)
(8)

Références

Télécharger maintenant ( PDF - 8 Page - 11.79 MB )

Documents relatifs

Double-walled carbon nanotube/zirconia composites: Preparation by spark plasma sintering, electrical conductivity and mechanical properties

However, with moderate DWCNT contents (up to 1.2 wt%, i.e. 3.9 vol% carbon), the fracture strength and fracture toughness reported together in the present work (Table 2) are almost

Microhardness and friction coefficient of multi-walled carbon nanotube-yttria-stabilized ZrO2 composites prepared by spark plasma sintering

Carbon debris were observed both on the ball and on the specimen for all composites tested, but the amount is much lower for S5, which is in line with the less noisy friction curve

The preparation of double-walled carbon nanotube/Cu composites by spark plasma sintering, and their hardness and friction properties

The minimum friction coefficient reported for the present DWCNT/Cu composites are obtained for a carbon content sig- nificantly lower (5 vol%) than contents reported for MWCNT/

Spark-plasma-sintering of double-walled carbon nanotube–magnesia nanocomposites

Indeed, the E-J composites sintered at a lower temperature do not show the microhardness increase although they have the same DWNTs content, MgO grain size and densification