• Aucun résultat trouvé

[PDF] Top 20 Towards III-V on silicon solar cells

Has 8419 "Towards III-V on silicon solar cells" found on our website. Below are the top 20 most common "Towards III-V on silicon solar cells".

Towards III-V on silicon solar cells

Towards III-V on silicon solar cells

... 3 University of Lyon, Lyon Institute of Nanotechnology (INL) UMR CNRS 5270, INSA de Lyon, Villeurbanne, France mickael.da-silva@insa-rennes.fr Towards III-V on silicon solar ... Voir le document complet

2

Exploring new convergences between PV technologies for high efficiency tandem solar cells : Wide band gap epitaxial CIGS top cells on silicon bottom cells with III-V intermediate layers

Exploring new convergences between PV technologies for high efficiency tandem solar cells : Wide band gap epitaxial CIGS top cells on silicon bottom cells with III-V intermediate layers

... Explor- ing new convergences between PV technologies for high efficiency tandem solar cells : Wide band gap epitaxial CIGS top cells on silicon bottom cells with III-V intermediate layers[r] ... Voir le document complet

7

Fabrication and investigation of III-V quantum structured  solar cells with Fabry-Pérot cavity and nanophotonics  in order to explore high-efficiency photovoltaic concepts : towards an intermediate band assisted hot carrier solar cell

Fabrication and investigation of III-V quantum structured solar cells with Fabry-Pérot cavity and nanophotonics in order to explore high-efficiency photovoltaic concepts : towards an intermediate band assisted hot carrier solar cell

... 4.1.3 Quasi-fermi level splitting The concept of quasi-Fermi level (QFL) is used to describe electrons and holes populations respec- tively in the conduction band (CB) and valence band (VB) when they are displaced from ... Voir le document complet

289

Computational design of high performance hybrid perovskite on silicon tandem solar cells

Computational design of high performance hybrid perovskite on silicon tandem solar cells

... the solar-cell ...group III-V multi-junction solar cells (MJSC), which combine absorbers with different bandgap energies allowing to harvest a wider range of the solar spectrum ... Voir le document complet

18

Multijunction photovoltaics: integrating III–V semiconductor heterostructures on silicon

Multijunction photovoltaics: integrating III–V semiconductor heterostructures on silicon

... In summary, we have developed promising building blocks for GaAsPN/silicon-based dual-junction solar cells. Concerning the top subcell development, we have obtained an efficient absorber by growing a ... Voir le document complet

4

Monolithic Integration of Diluted-Nitride III–V-N Compounds on Silicon Substrates: Toward the III–V/Si Concentrated Photovoltaics

Monolithic Integration of Diluted-Nitride III–V-N Compounds on Silicon Substrates: Toward the III–V/Si Concentrated Photovoltaics

... those solar cells, we have studied a second structure with a 30- nm-thin GaP window layer (as compared to the 250-nm- thick previous one), a ...on solar cells with p- and n-doped absorber show ... Voir le document complet

11

Contact electrodes for heterojunction silicon solar cells: Evaluations and optimizations of the electron contact

Contact electrodes for heterojunction silicon solar cells: Evaluations and optimizations of the electron contact

... An approximately 70nm thick Transparent Conductive Oxide (or TCO), in most cases Indium Tin Oxide (ITO), is subsequently deposited on top of the a-Si:H layers. This deposition is usually carried out using Physical Vapor ... Voir le document complet

205

III-V/Si tandem solar cells : an inverted metamorphic approach using low temperature PECVD of c-Si(Ge)

III-V/Si tandem solar cells : an inverted metamorphic approach using low temperature PECVD of c-Si(Ge)

... 29 information on surface and give its optical constants, its roughness and thickness. In this work, we used it mainly to have a quick estimation of the thickness of the Si film, and to assess its crystallinity, by ... Voir le document complet

196

23.6%-efficient monolithic perovskite/silicon tandem solar cells with improved stability

23.6%-efficient monolithic perovskite/silicon tandem solar cells with improved stability

... with silicon cell fabrication and ...NextGen III program under award number DE-EE0006707, the National Science Foundation (NSF) and Department of Energy under NSF Cooperative Agreement ...(Ulbrich ... Voir le document complet

28

Hybrid solar cells based on thin-film silicon and P3HT

Hybrid solar cells based on thin-film silicon and P3HT

... of solar cells through a better use of the solar spectrum, a higher aspect ratio of the interface, and the good processability of ...of solar cells has been ...and silicon as an ... Voir le document complet

5

Study of silicon solar cells performances using the impurity photovoltaic effect

Study of silicon solar cells performances using the impurity photovoltaic effect

... our silicon solar cell parameters; in this last part, the focus is on what influence light trapping has on the solar cell ...Thick silicon layer does not absorb efficiently the infrared light ... Voir le document complet

99

Towards anode with low indium content as effective anode in organic solar cells

Towards anode with low indium content as effective anode in organic solar cells

... AFM images on different sites of the films were taken at atmo- spheric pressure and room temperature. All measurements were performed in tapping mode (Nanoscope IIIa, (Veeco, Inc.). Classi- cal silicon cantilevers ... Voir le document complet

8

Towards anode with low indium content as effective anode in organic solar cells

Towards anode with low indium content as effective anode in organic solar cells

... AFM images on different sites of the films were taken at atmo- spheric pressure and room temperature. All measurements were performed in tapping mode (Nanoscope IIIa, (Veeco, Inc.). Classi- cal silicon cantilevers ... Voir le document complet

7

Design of a lattice-matched III-V-N/Si photovoltaic tandem cell monolithically integrated on silicon substrate

Design of a lattice-matched III-V-N/Si photovoltaic tandem cell monolithically integrated on silicon substrate

... tandem solar cell is the TJ interconnecting both top and bottom ...for Silicon (Lavery 2008) and for III-V semiconductors (Baudrit et al 2008; Baudrit et al 2010; Allen ... Voir le document complet

8

Building blocks development for defect-free growth of GaAs on silicon for tandem solar cells

Building blocks development for defect-free growth of GaAs on silicon for tandem solar cells

... on silicon of GaAs, and more generally of III-V semiconductors, is a very attractive and promising route for the production of high efficiencies multijunctions devices in the manner of those ... Voir le document complet

5

GaAsPN-based PIN solar cells MBE-grown on GaP substrates: toward the III-V/Si tandem solar cell

GaAsPN-based PIN solar cells MBE-grown on GaP substrates: toward the III-V/Si tandem solar cell

... tandem solar cells on silicon ...targeted solar cell top junction. Early stage GaAsPN PIN solar cells prototypes have been grown on GaP (001) substrates, with 2 different ... Voir le document complet

11

Computational analysis of hybrid perovskite on silicon 2-T tandem solar cells based on a Si tunnel junction

Computational analysis of hybrid perovskite on silicon 2-T tandem solar cells based on a Si tunnel junction

... concentrator solar cells with ...diluted-nitride IIIV–N com- pounds on silicon substrates: toward the IIIV/Si Concentrated ... Voir le document complet

14

Modeling of Perovskite Solar Cells, III-V Optoelectronic Devices and Kelvin Probe Microscopy

Modeling of Perovskite Solar Cells, III-V Optoelectronic Devices and Kelvin Probe Microscopy

... on silicon has attracted much interest in the past decade, especially the hybrid integration with III-V materials 192 ...the III-V/Si hetero-epitaxy are known to limit nowadays laser ... Voir le document complet

133

Investigation of Hybrid Tunnel Junction Architectures for III-V/Si Tandem Solar Cells

Investigation of Hybrid Tunnel Junction Architectures for III-V/Si Tandem Solar Cells

... n-type Si films were grown by PECVD at 175°C from the dissociation of a SiH 4/ H 2 mixture combined with phosphine (PH 3 ). Figure 2 shows the imaginary parts of the pseudo-dielectric function of n-doped silicon ... Voir le document complet

6

Anti-reflection zinc oxide nanocones for higher efficiency thin-film silicon solar cells

Anti-reflection zinc oxide nanocones for higher efficiency thin-film silicon solar cells

... the solar cell, and the cell efficiency is ...efficient solar cell while keeping the solar cell structure constraint ...a solar cell, including the glass, Transparent Conducting Oxide (TCO), ... Voir le document complet

80

Show all 8419 documents...