• Aucun résultat trouvé

[PDF] Top 20 Thermodynamic modelling of the Cr–Fe–Ni–O system

Has 10000 "Thermodynamic modelling of the Cr–Fe–Ni–O system" found on our website. Below are the top 20 most common "Thermodynamic modelling of the Cr–Fe–Ni–O system".

Thermodynamic modelling of the Cr–Fe–Ni–O system

Thermodynamic modelling of the Cr–Fe–Ni–O system

... describe the influence of oxygen on high alloyed steels, both regarding oxidation processes – as in the formation of oxide layers – and regarding steel/slag processes in a metallurgical ... Voir le document complet

17

Experimental study, first-principles calculation and thermodynamic modelling of the Cr–Fe–Nb–Sn–Zr quinary system for application as cladding materials in nuclear reactors.

Experimental study, first-principles calculation and thermodynamic modelling of the Cr–Fe–Nb–Sn–Zr quinary system for application as cladding materials in nuclear reactors.

... 2.1.3 Thermodynamic assessment The thermodynamic modelling performed by Andersson and Sundman [11] with the description of the liquid phase corrected by Lee [12] is ... Voir le document complet

42

Experimental investigations and thermodynamic modelling of the Cr-Nb-Sn-Zr system

Experimental investigations and thermodynamic modelling of the Cr-Nb-Sn-Zr system

... Our thermodynamic description of the Cr–Zr system was carried out using similar parameters as the one of Lu et ...addition, the phase diagram shown in Fig. 3 ... Voir le document complet

35

Thermodynamic modelling of the Fe-Sn-Zr system based on new experiments and first- principles calculations

Thermodynamic modelling of the Fe-Sn-Zr system based on new experiments and first- principles calculations

... that the C16 phase is not stable down to 0 ...calculated the formation enthalpy of the C16 ...on the stability of this phase only considering the negative value of ... Voir le document complet

33

Thermodynamic Assessment of the Fe-Te System. Part II Thermodynamic modelling

Thermodynamic Assessment of the Fe-Te System. Part II Thermodynamic modelling

... with the EMF data by Geiderikh ...fit the isopiestic activity data by Ipser et ...with the EMF and partial pressure data sets. As can be seen in the figures, the thermodynamic ... Voir le document complet

25

Thermodynamic Assessment of the Fe-Te System. Part I: Experimental study

Thermodynamic Assessment of the Fe-Te System. Part I: Experimental study

... boundaries of two-phase samples evaluated from the composition analyses via EDS and ...WDS. The respective tie-lines are shown in Figure 2, imposed on the calculated phase diagram compared ... Voir le document complet

24

Mechanism of breakaway oxidation of Fe–Cr and Fe–Cr–Ni alloys in dry and wet carbon dioxide

Mechanism of breakaway oxidation of Fe–Cr and Fe–Cr–Ni alloys in dry and wet carbon dioxide

... 24 Fe–20Cr–10Ni and Fe–20Cr–20Ni Nodules grown on Fe–20Cr–10Ni and Fe–20Cr–20Ni were morphologically similar to those found on ...Fe–20Cr. The composition of the ... Voir le document complet

30

Thermodynamic study of (U-Pu-Zr-O-Fe) corium system

Thermodynamic study of (U-Pu-Zr-O-Fe) corium system

... PURPOSE OF THE WORK In case of severe accident in a pressurized water reactor (PWR), the nuclear oxide fuel (UO 2±x or (U,Pu)O 2±x ) could react with the Zr-alloy cladding and ... Voir le document complet

2

Heat Resistant Ni-Cr-Fe Steels for Superplastic Forming Dies: From Material Microstructure to Die Design

Heat Resistant Ni-Cr-Fe Steels for Superplastic Forming Dies: From Material Microstructure to Die Design

... reports the rupture stresses obtained for four grades containing increasing Ni ...only the ferritic grade (0,5% Ni) behaves differently as the brittleness is ...temperatures the ... Voir le document complet

9

Tracer diffusion of Cr in Ni and Ni-22Cr studied by SIMS

Tracer diffusion of Cr in Ni and Ni-22Cr studied by SIMS

... logarithms, the erfc function does not transform products into ...for the proportion- ality constant is required ...source of error. A sensible approach, then, is to use the thin-film solution ... Voir le document complet

19

Oxygen permeability of Fe-Ni-Cr alloys at 1100 and 1150 °C under carbon-free and carbon-containing gases

Oxygen permeability of Fe-Ni-Cr alloys at 1100 and 1150 °C under carbon-free and carbon-containing gases

... function of N (0) Cr Measured values of k ðiÞ p and calculated enrichment factores were used to construct the plots displayed in ...at the higher chromium content above the ... Voir le document complet

9

Oxygen permeability of Fe-Ni-Cr alloys at 1100 and 1150 °C under carbon-free and carbon-containing gases

Oxygen permeability of Fe-Ni-Cr alloys at 1100 and 1150 °C under carbon-free and carbon-containing gases

... function of N (0) Cr Measured values of k ðiÞ p and calculated enrichment factores were used to construct the plots displayed in ...at the higher chromium content above the ... Voir le document complet

10

Phase equilibria and phase transformations in the Ti-rich
corner of the Fe-Ni-Ti system

Phase equilibria and phase transformations in the Ti-rich corner of the Fe-Ni-Ti system

... along the FeTi 2 –NiTi 2 line were prepared by arc melting small pieces of the pure elements ...wt% Fe, 99.99 wt% Ni, and 99.98 wt% Ti) in an argon atmosphere. The alloys were ... Voir le document complet

14

Irradiation behavior of austenitic binary model alloys Ni, Ni-Ti and Ni-Cr

Irradiation behavior of austenitic binary model alloys Ni, Ni-Ti and Ni-Cr

... for the deposit and dissemination of sci- entific research documents, whether they are pub- lished or ...not. The documents may come from teaching and research institutions in France or abroad, or ... Voir le document complet

2

Thermodynamic modeling of the NbeB system

Thermodynamic modeling of the NbeB system

... optimization of the NbeB system available in the literature is due to Kaufman et ...In the modeling of the MeeSieB systems, we have been using the Stable Element ... Voir le document complet

8

Combining DFT and CALPHAD for the development of on-lattice interaction models: The case of Fe-Ni system

Combining DFT and CALPHAD for the development of on-lattice interaction models: The case of Fe-Ni system

... lations of vibration entropy, for example, are in principle possible but are computationally expensive and are usually limited to simple systems ...Modeling the effect of magnetic transitions and ... Voir le document complet

32

Thermodynamic Assessment of the Cu-Pt System

Thermodynamic Assessment of the Cu-Pt System

... on the same sublattice. The regular parameters, 0 L Cu,Pt:k:l:m , in Eq 4, can be given approximately by the second nearest- neighbor interaction energy under the assumption of ran- dom ... Voir le document complet

10

Modélisation de l'oxydation à haute température des alliages Ni-Cr

Modélisation de l'oxydation à haute température des alliages Ni-Cr

... alliage Ni-30Cr oxydé à 1173 K, la croissance des grains d’oxyde au cours de l’oxydation peut jouer de manière importante sur les valeurs de k p expérimentales ... Voir le document complet

236

Statistical lifetime modeling of Fe-Ni-Cr alloys subject to high-temperature corrosion in waste-to-energy production units

Statistical lifetime modeling of Fe-Ni-Cr alloys subject to high-temperature corrosion in waste-to-energy production units

... 2 O 3 ) as a protective film that contributes to corrosion resistance depending on the ...32 The unexpected positive correlation between Cu, Nb, Ti and MTLr may be explained by the fact that ... Voir le document complet

28

Novel Co 20 Cr 15 Fe 26 Mn 17 Ni 22 ultra-fine grained high-entropy alloy

Novel Co 20 Cr 15 Fe 26 Mn 17 Ni 22 ultra-fine grained high-entropy alloy

... NOVEL COMPOSITION: based on equiatomic CoCrFeMnNi • Reference alloy (Yeh, Cantor, 2004) • Face-Centered Cubic structure (lattice parameter a = 3.6Å) • Yield strength of ~240MPa (recrystallized) and ~760MPa ... Voir le document complet

2

Show all 10000 documents...